Goldstar CDU 1435SE/GS11 Pocket Service Manual

Manual is about: 14" COLOUR DISPLAY UNIT

Summary of CDU 1435SE/GS11

  • Page 1

    14" colour display unit - cdu 1435se/gs11 this unit is manufactured by goldstar and bears the marking cdu 1435s/gs11 on the rear and dsm 27-039 on the progetto di gestione. It can display 5 different vertical resolution: 350, 400, 480 lines (vga standard mode); 600 lines (super vga mode) and 768 lin...

  • Page 2

    Removing the cover 1. Position the display as shown in the figure; put a cloth on the table under the unit so as not to scratch the crt glass screen. Remove the 4 cover securing screws v1, v2, v3 and v4. 2. Take the cover off; take care not to d a mag e th e ca b l e s o r bo ard components. Dischar...

  • Page 3

    Removing the video amplifier board 4. Remove the monitor cover as described in the paragraph "removing the cover". 5. Remove the silicon solution attaching the crt to the connector of the video amplifier board (used for security of transport). 6. Unscrew screw a attaching the ground cable, that conn...

  • Page 4

    Removing the main board 12. Discharge the anode, as described in the p a ra gra ph "d is ch a r gin g t h e h igh voltage", before starting to work on the monitor. 13. Remove the video amplifier board as described in the paragraph "removing the video amplifier board". Note: disconnect the anode suct...

  • Page 5

    Replacing the video signals cable 18. If the signals cable needs replacing, disconnect the cable and unscrew the screws a fixing it. Removing the crt note: in addition to the cathode ray tube, the crt also comprises the deflection yoke and the geometric distortion regulation magnets. These magnets s...

  • Page 6

    Video adjustments adjustment trimmers the following list illustrates the trimmers to be used in making video adjustments. The sequence illustrated below should be performed step by step as some of the adjustments influence those that follow. Video amplifier board vr301 blue cut-off vr302 green cut-o...

  • Page 7

    Main board vr201 horizontal phase 123 adjustment vr202 horizontal phase adjustment vr501 green drive adjustment vr502 blue drive adjustment vr602 vertical size adjustment (external access) vr601 vertical linearity adjustment vr603 vertical center adjustment (external access) vr702 horizontal hold ad...

  • Page 8

    Main board adjustments the main board setting procedures described in this section guarantee correct setting of the video unit. It is important to respect the order in which the procedures are listed for best results. Note: in performing these setting an electrostatic voltmeter and an electronic vol...

  • Page 9

    Side pincushion adjustment • system test: cross hatch pattern. • adjust the vr710 so as to minimize the pincushion distortion. Horizontal size adjustment • system test: cross hatch pattern. • adjust vr708 (external vr) for the horizontal size as to be within 240 ± 2 mm. • then the bright control sho...

  • Page 10

    Focus adjustment • system test: check linearity, that display the "h" character in full screen. • set the bright vr at the center and the contrast vr at max. • adjust focus vr, on t702 transformer, so that the focus should be best condition ■ t702 fig. 20-16 focus adjustment video unit - pocket serv...