Golight 2020 Instruction Manual - page 2
OPERATION OF GOLIGHT®
1. Use the toggle switch on the dash control to turn the light on/off.
2. The 4-way joystick on the dash control rotates your light to the
desired
location.
BULB REPLACEMENT
The Golight® utilizes a Philips® H-9 bulb, which may be purchased
through Golight, Inc. — 308.278.3131 or 800.557.0098.
✱
This light is for off road and utility use only. It is not designed for
road use as a driving light.
✱
FCC RULE Part. 15.21 - Changes or modifications made by the
user not expressly approved by Golight, Inc. for compliance could void
the user’s authority to operate the equipment.
For safe and efficient operation of your Golight®, observe these
guidelines:
Using your Golight® in icing conditions could damage the gear
motors. (Optional dome available - see accessory sheet.)
The Golight® Model 2020 is designed to be permanently attached to a
vehicle. The Searchlight with Directional Flexibility is controlled by a
dash-mount remote, which gives the operator a full 370
°
horizontal
rotation and a 135
°
vertical tilt with fingertip control. The Golight®
provides superior light penetration with Cr5 PentaBeam™ technology.
The Golight® Includes:
• Golight® Searchlight
• Dash-Mount Remote Control (with quick connects.)
• 20' 6 Wire Cord with Positive & Negative 12 Volt Wire
• Permanent Mounting Gasket
• Screws and Caps
MOUNTING INSTRUCTIONS:
Determine location of dash-mount remote. Create an opening and
insert dash-mount remote with correlating quick connect on 20' cord.
Connect power wires to 12 v D.C.
The 12 Volt DC power wire should be joined to the leads on the 20'
cable with appropriate automotive wire attachments. It is critical that
polarity be observed. The (+) lead of the Golight® is marked with a red
tag. The power should be fused at 15 Amps and be on an ignition
switched circuit if possible.
Determine location for Golight®. (Extra 10' and 20' quick connect
cords are available, if needed.) Create opening for Golight® cord.
Place gasket on Golight® and attach correlating quick connect to
Golight®. Use silicone sealant to fill opening. Set light in place and
mount light base to surface with screws provided. Cover screws with
the 4 white caps provided.
Attach Dash-Mount Remote to designated location with screws.
Unit is installed.
IMPORTANT SAFETY INFORMATION
✱
This symbol is to alert you to important operating or servicing
instructions that appear in your instructions. Always follow basic
safety precautions when using this product to reduce the risk of
injury, fire or electric shock.
www.magnalight.com
1-800-369-6671
903-498-3363
sales@magnalight.com