Golmar EL632 GB2 User manual

Manual is about: Video Door Entry System Kit 2-wire installation Nexa Modular

Summary of EL632 GB2

  • Page 1

    User manu al code 50122084 tkit632a vesta2 en rev.0117 gb2 video door entry system kit 2-wire installation nexa modular.

  • Page 2

    Nexa modular gb2 video door entry system kit - villas introduction first and foremost we would like to thank you for purchasing this product. Our commitment to satisfying our customers can be seen from our iso-9001 certification and from the manufacturing of products like this one. Its advanced tech...

  • Page 3

    Characteristics - video door entry system with simplified installation (non-polarised 2 wire bus). - up to 4 access panels (dp-gb2a distributor required for more than one access panel) per installation. - up to 2 apartments (n5110 vesta2 1-apartment kit and n5220 vesta2 2-apartment kit) per installa...

  • Page 4

    Description of the el632 gb2 sound module a 4 microphone. Speaker. Front. Sound module push buttons (x2). Connection block (gb2 bus). Push button connector (in unused). Villas back. Positive, negative (12vdc output for golmar dc lock ). : release : lock release contact “c” for (relay 1). : lock rele...

  • Page 5

    Description of the nexa modular door panel 5 sound module el632 gb2 video door entry system with colour camera. A, door panel component assembly drawing: aluminium panel sound module frame module embedding box description of the door panel: door panel installation ncev-90cs embedding box: 99(w) x 13...

  • Page 6

    6 preparing the cable entry: door panel installation installation break the flange to allow entry of cables through the bottom part of the embedding box. Pass the cable through the hole made in the embedding box. Embed the box and ensure that it is level and flush. Once embedded, remove the protecti...

  • Page 7

    7 door panel installation codes assigned to the call buttons of the sound module: c 16 31 odes - c s 0 15 ode - p1 p2 p2 the sound module’s p1 and p2 push buttons are assigned with factory codes. - : . Apartment 1, push button “p1” assigned with codes 0-15 monitors in this apartment must be set with...

  • Page 8

    8 door panel installation description of the configuration jumper: 1 2 3 4 5 6 on + c1 _ 1 important: do not change the factory default position of the configuration jumper. Description of the door panel led lights (for low light conditions): the door panel led lights will turn on during a call if t...

  • Page 9

    9 door panel installation adjusting the door panel communication volume: if after starting the system the door panel audio volume seems inadequate, follow these steps: - call an apartment. - the call is received in the apartment. Establish communication by pressing the push button on the monitor. - ...

  • Page 10

    10 door panel installation closing the frame: configuring the contact type for relay 1 and relay 2 (lock release): inserting the push button identification labels: open the label holder. Insert the label and close. Closing the door panel: finish the door panel assembly by placing the closing heads, ...

  • Page 11

    11 power supply unit installation fa-gb2/a power supply installation instructions: replace the protective cover once the input terminals have been wired. Please note that current regulations stipulate that the power supply must be protected by a circuit thermo-magnetic breaker. Connect the fa-gb2/a ...

  • Page 12

    Wiring diagrams: one apartment kit (n5110 vesta2 kit) and golmar dc lock release. 12 na2 + ap- c1 na1 ap+ c2 ap+ ap- p1 p2 busbus relay 2 relay 1 _ 12vdc lock release max. 12 vdc/270ma. On 1 2 3 4 5 6 ap sw1 ( ) 1 ( ) 1 access panel door vesta2 bus code 0 two apartment kit (n5220 vesta2 kit) and gol...

  • Page 13

    Wiring diagrams: one apartment kit (n5110 vesta2 kit) with monitors in parallel (in-out) and golmar dc lock release. 13 two apartment kit (n5220 vesta2 kit) with monitors in parallel (in-out) and golmar dc lock release. Configuring the end of line in the last monitor. Dip 6 to on. * important: for a...

  • Page 14

    Wiring diagrams: one apartment with 16 vesta2 monitors, 4 dp-gb2 distributors and golmar dc lock release. A 14 configuring the end of line in the last monitor. Dip 6 to on. Access panel door ** lock release max. 12 vdc/270ma. Bus bus bus bus bus bus bus bus d c b a dp- 2 gb a bus bus bus bus end of ...

  • Page 15

    Wiring diagrams: one apartment with 16 vesta2 monitors, 8 d2l-gb2 distributors and golmar dc lock release. 15 configuring the end of line in the last monitor. Dip 6 to on. ** na2 + ap- c1 na1 ap+ c2 ap+ ap- p1 p2 busbus relay 2 relay 1 _ 12vdc lock release max. 12 vdc/270ma. Bus bus bus bus d2 d1 d2...

  • Page 16

    Wiring diagrams: two apartments with 23 vesta2 monitors, 6 dp-gb2 distributors and golmar dc lock release. A 16 configuring the end of line in the last monitor. Dip 6 to on. Access panel door ** lock release max. 12 vdc/270ma. Bus bus bus bus bus bus d c b a dp- 2 gb a bus bus end of line end of lin...

  • Page 17

    Wiring diagrams: dos viviendas 3 vesta2 12 2l gb con 2 monitores , distribuidores d - 2 y abrepuertas de continua golmar. 17 configurar final de línea en el último monitor. Dip 6 to on. ** na2 + ap- c1 na1 ap+ c2 ap+ ap- p1 p2 busbus relay 2 relay 1 _ 12vdc lock release max. 12 vdc/270ma. On 1 2 3 4...

  • Page 18

    Wiring diagrams: 18 bus bus bus bus d c b a dp- 2 gb a end of line off ap ap access panel door 2 on 1 2 3 4 5 6 sw1 access panel door 1 on 1 2 3 4 5 6 sw1 ap ap access panel door 3 on 1 2 3 4 5 6 sw1 access panel door 4 on 1 2 3 4 5 6 sw1 (1) (1) (1) (1) lock release max. 12 vdc/270ma. Lock release ...

  • Page 19

    Access panel door on 1 2 3 4 5 6 sw1 na2 + ap- c1 na1 ap+ c2 ap+ ap- p1 p2 busbus _ ap1 na2 + ap- c1 na1 ap+ c2 ap+ ap- p1 p2 busbus relay 2 relay 1 _ 12vdc connection of 2 dc lock releases without “ap”: important: with 2 dc lock releases, it is not possible to use the “ap” door opening buttons. (1)...

  • Page 20

    Golmar@golmar.Es www.Golmar.Es sistemas de comunicación s.A. Golmar se reserva el derecho a cualquier modificación sin previo aviso. Golmar se réserve le droit de toute modification sans préavis. Golmar reserves the right to make any modifications without prior notice. Golmar s.A. C/ silici, 13 0894...