Audio door entry system kits with access control stadio plus t4003en rev.0105 golmar se reserva el derecho a cualquier modificación sin previo aviso. Golmar se réserve le droit de toute modification sans préavis. Golmar reserves the right to make any modifications without prior notice. Golmar@golmar...
1 index introduction..........................................1 system characteristics ............................1 index ...................................................1 power supply installation.........................2 door panel installation.....................2 to 4 access control descri...
Power supply installation 2 3 door panel installation din 46277 f3,5 x 25 din-7971 f3,5 x 25 din-7971 nstalling the tf-104 transformer. I to install the transformer directly on the wall, insert the fixing flanges. Drill two holes of Ø6mm. And insert the wallplugs. Fix the transformer with the specif...
Access control description 5 4 access control programming door panel installation lace the nameplate labels. P open the label holder. Place the label and close. Inal adjustments. F if after starting the system it's considered that the audio volume isn't correct, proceed with the necessary adjustment...
7 access control programming 6 acces control programming nter and exit from e programming. Rogramming structure p and sequence. To enter into the programming menu, press key symbol and enter the installer pin code (factory default: 271828) or the user pin code (factory default: 314159). To exit from...
9 8 access control programming acces control programming it defines the 7th activation code of the relay n.1. Proceed as detailed on 11 field. It defines the 8th activation code of the relay n.1. Proceed as detailed on 11 field. It defines the 1st activation code of the relay n.2. Proceed as detaile...
11 10 access control programming uplicated codes. D 1 0 or it defines the installer pin code to enter into programming mode. A 6 digits code must be always used. Once this code has been introduced, 2 acoustic tones will be heard: introduce the code again and 4 slow acoustic tones will be heard to co...
M 4 x 8 f3,5 x 25 din-7972 din-963 installation diagram 13 lock release installation 12 udio door entry system. A cv cp l1 l2 ind. 1 ind. 2 p cn1 - ~1 ~2 sound module tf-104 sec ~ ~ pri ~ ~ mains c2 nc2 na2 b+ b- c1 n1 cn1 p ~ ~ 1 4 7 2 5 8 3 6 0 9 c access control ind. 1 0 10 5 3 p1 ind. 2 0 10 5 3...
15 sec ~ ~ pri ~ ~ mains tf-104 transformer nd relay connection. 2 relay nr. 1 is reserved for the connection of the door panel lock release, as it's shown on previous page. Relay nr. 2 operates on single shoot mode only. Use a tf-104 transformer to connect a 2nd lock release; wire them as it's show...
Troubleshooting hints 17 16 page intentionally left blank. O nothing operates. W check the output transformer voltage between sec terminals: it should have 12 to 17va.C. If not, disconnect the transformer from the installation and measure again. If it's correct now, it means there is a short circuit...
Golmar se reserva el derecho a cualquier modificación sin previo aviso. Golmar se réserve le droit de toute modification sans préavis. Golmar reserves the right to make any modifications without prior notice. Golmar@golmar.Es www.Golmar.Es.
