1. DL manuals
  2. Golmar
  3. Intercom System
  4. Stadio Plus T500EN
  5. Instruction Manual

Golmar Stadio Plus T500EN Instruction Manual

Manual is about: Audio and Video door entry system digital

Summary of Stadio Plus T500EN

  • Page 1

    Stadio plus t500en rev.0205 instructions manual audio and video door entry system digital installation golmar se reserva el derecho a cualquier modificación sin previo aviso. Golmar se réserve le droit de toute modification sans préavis. Golmar reserves the right to make any modifications without pr...

  • Page 2

    2 1 system characteristics system operation introduction starting recommendations index first of all we would like to thank and congratulate you for the purchase of this product manufactured by golmar. The commitment to reach the satisfaction of our customers is stated through the iso-9001 certifica...

  • Page 3

    Modules model w h d 4 3 door panel installation door panel description oor panel description. D 1xxx 2xxx grille module 600 closing heads 3xxx push buttons module ce-6xx embedding boxes sound module el530 el531 el540 , on video systems with b/w camera. , on video systems with color camera. , on audi...

  • Page 4

    6 5 door panel installation door panel installation to assembly the el516 encoder, screw the top tab of the case to the corresponding plastic lug of the embedding box. In case of more than one encoder, place them underneath or in the next embedding box. The use of el516 encoders is only necessary fo...

  • Page 5

    8 7 ableado de los c pulsadores. Door panel installation door panel installation link the sound module with the el500 microprocessed circuit by using the supplied flat cable. Select a direction to open the door panel; this selection should ease the door panel wiring. The opening direction will be se...

  • Page 6

    10 9 to the 1 st push b. Or to the p terminal of the 1 st el516. To the next push b. Or to the p terminal of the 2 nd el516. To the next push b. Or to the p terminal of the 3 rd el516. To the next push b. Or to the p terminal of the 4 th el516. To the next push b. Or to the p terminal of the 5 th el...

  • Page 7

    12 11 door panel installation door panel installation jumper jp1 loads the installation with a communications resistor. For a proper system operation, activate this resistor only in the closest door panel to the backbone installation or in the general entrance door panel (if exists). Factory default...

  • Page 8

    14 13 amps wiring. L door panel installation lock release installation nstalling the fa-plus and fa-plus/c power supplies. I din 46277 f 3,5 x 25 din-7971 f 3,5 x 25 din-7971 if the lock release will be installed in a metal door, use a Ø3,5mm. Drill and tap the hole. In case of wood door, use a Ø3mm...

  • Page 9

    16 15 on-off push button. After any monitor reset and during the next 45 seconds, all the monitor functions will be disabled, with the exception of call reception. If the handset is on the craddle allows the activation of an optional second camera (*). If not, allows to make an intercom call or to a...

  • Page 10

    18 17 v in v out malla shield malla shield a hz- int sa cto 2c a1 vp mp d ref rcpl-plus lote code 11758882 colocar la parte superior de la regleta a 1,60m. Del suelo. Place the top part of the monitor connector at 1,60m. From the floor. 50mm. 50mm. Presionar para abrir. Press to open. Terminals +, –...

  • Page 11

    20 19 avoid to place the monitor near to heating sources, in dusty locations or smoky environments. To install the monitor directly over the wall, drill two holes of Ø6mm. And use the supplied screws. The upper part of the monitor connector must be placed at 1,60m. Height roughly. The minimum distan...

  • Page 12

    22 21 telephone description telephone description escription of the t-940 plus d telephone. A. B. C. D. E. F. G. H. I. Telephone handset. Speaker grille. Microphone hole. Subjection hole. Telephone cord connectors. Function push buttons. On-off light indicator. Call reception volume control. Hook sw...

  • Page 13

    24 23 telephones programming rogramming the p telephones. Set to on the switch number 2 of the configuration dip switch, that's accessible by opening the terminal connector protection cover. The door panel will reproduce a sound to advise that the system has entered into programming mode. In systems...

  • Page 14

    26 25 fa-plus/c or fa-plus fa-plus/c sec pri ~ ~ + + - - sec pri ~ ~ + + - - cv+ cv- d malla v in- a in a out v in+ v out- v out+ + cn1 - cv+ cv- d malla v in- a in a out v in+ v out- v out+ + cn1 - sw1 sw1 jp 4 3 2 1 jp 4 3 2 1 a a _ _ + + d d malla malla v in v in v out v out cn4 cn4 a _ + d malla...

  • Page 15

    28 27 sec pri ~ ~ + + - - fa-plus/c sec pri ~ ~ + + - - cv+ cv- d malla v in- a in a out v in+ v out- v out+ + cn1 - cv+ cv- d malla v in- a in a out v in+ v out- v out+ + cn1 - sw1 sw1 jp 4 3 2 1 jp 4 3 2 1 fa-plus/c or fa-plus main main slave door panel master door panel *place this power supply a...

  • Page 16

    30 29 sec pri ~ ~ + + - - a a + + _ _ d d t-940 plus t-940 plus a + _ d t-940 plus a + _ d t-940 plus fa-plus/c sec pri ~ ~ + + - - cv+ cv- d malla v in- a in a out v in+ v out- v out+ + cn1 - cv+ cv- d malla v in- a in a out v in+ v out- v out+ + cn1 - sw1 sw1 jp 4 3 2 1 jp 4 3 2 1 fa-plus/c or fa-...

  • Page 17

    32 31 sa + t t r r m m sar-90 sa + t t r r m m sar-90 tf-104 sec ~ ~ cv+ cv- - a + _ d int a _ + d a1 malla v in v out cn4 a _ + d a1 malla v in v out cn4 a _ + d int malla v in v out cn4 a _ + d malla v in v out cn4 optional connections optional connections the lock release can be activated at any ...

  • Page 18

    34 33 optional connections troubleshooting hints hz- - oor bell push button connection. D the platea plus monitor and the t-940 plus telephone can be used to receive the calls made from the apartment door, saving the use of a bell. Wire the push button of the apartment door to the 'hz ' and ' ' moni...