Golzer GBAR-30 User Manual - page 3
3. Plug the other end of the cable into the Micro USB port on your Stereo Bluetooth
Receiver GBAR-30 device.
Note:
The LED indicator keeps in red when charging and it will turn off when GBAR-30 is
fully charged.
Turning on / off the receiver
To turn on the receiver
Insert the earphone into 3.5mm jack and then press and hold button (3) until the LED
flashes in red and blue alternatively and a “beep” sound heard.
To turn off the receiver
Press and hold button (3) until the LED flashes in blue and a “beep” sound
heard then release.
Pairing the receiver with your phone
You can pair the receiver with your phone manually or using NFC. After successful
pairing, the receiver connects automatically to the phone as soon as the receiver is
turned on and within range.
To manually pair the receiver with your phone
1. Make sure your mobile phone is Bluetooth-enabled and the Bluetooth function is
activated.
2. Turn on the receiver.
3. Receiver: Turn off the receiver and then Press and hold the MFB button (3) until
the LED indicator flashes in red and blue alternatively.
4. Phone: Scan for Bluetooth devices, then select “ GBAR-30" in the available
devices list.
5. Follow the pairing instructions that appear on your phone. If a passcode is
required, enter “ 0000".
6. Go back to your mobile phone’s main menu. Some mobile phone, when they are
re-started, the receiver will be connected with the mobile phone automatically.
To pair the receiver with your mobile phone via NFC
1. Make sure that the NFC function of you mobile phone is turned on and that the
phone screen is active.
2. Turn on the receiver.
3. Place your phone over the receiver so that the NFC detection area of each device
touches the other.
4. Follow the pairing instructions that appear on your phone. If a passcode is
required, enter “0000".