Good Sam RVND 5525 LM User Manual - page 2

Good Sam GPS User Manual

FCC Compliance Statement

This device complies with part 15 of the FCC rules. Operation is subject  

to the following two conditions: (1) this device may not cause harmful 

interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits  

for a Class B digital device, pursuant to part 15 of the FCC rules. These 

limits are designed to provide reasonable protection against harmful  

interference in a residential installation. This equipment generates,  

uses, and can radiate radio frequency energy and may cause harmful  

interference to radio communications if not installed and used in  

accordance with the instructions. However, there is no guarantee that  

interference will not occur in a particular installation. If this equipment 

does cause harmful interference to radio or television reception, which  

can be determined by turning the equipment off and on, the user is  

encouraged to try to correct the interference by one of the  

following measures:

•  Reorient or relocate the receiving antenna.

•  Increase the separation between the equipment and the receiver.

•  Connect the equipment into an outlet that is on a different circuit 

from the GPS unit.

•  Consult the dealer or an experienced radio/TV technician for help.

IC Compliance Statement

This device complies with Part 15 of the FCC Rules and Industry Canada 

license-exempt RSS standard(s). Operation is subject to the following  

two conditions:  

1.  This device may not cause interference, and 

2.  This device must accept any interference, including interference  

that may cause undesired operation of the device.

IC Caution

Intentional or unintentional changes or modifications to the equipment 

not expressly approved by Rand McNally could void the user’s authority  

to operate the equipment.

IC attestation de conformité

Ce dispositif est conforme à la norme FCC Partie 15 et aux norme(s)  

RSS permis-exempte(s) d’Industrie Canada. L’opération est soumise  

aux deux conditions suivantes:  

3.  Ce dispositif ne peut pas provoquer d’interférence nocive et 

4.  Ce dispositif doit accepter toute interference reçue, y compris  

les interférences qui peuvent causer un mauvais fonctionnement  

du dispositif.

Attention 

Les changements ou modifications à l’équipement, que ce soient  

intentionnelles ou non, non expressément approuvés par Rand McNally 

pourraient annuler l’autorisation de l’utilisateur à utiliser cet équipement.

IC: 10199A-01001A

i