Good Will Instrument PSS-2005 User Manual - page 7
PSS-3203/2005 PROGRAMMABLE POWER SUPPLY
USER MANUAL
5
3.PRECAUTIONS BEFORE OPERATION
3-1.Unpacking the Instrument
The product has been fully inspected and tested before shipping from the
factory. Upon receiving the instrument, please unpack and inspect it to
check if there is any damage caused during transportation. If any sign of
damage is found, notify the bearer and/or the dealer immediately.
3-2.Checking the Line Voltage
The product can be applied by any kind of line voltages shown in the table
below. Before connecting the power plug to an AC line outlet, make sure
the voltage selector of the rear panel is set to the correct position
corresponding to the line voltage. It might be damaged the instrument by
connecting to the wrong AC line voltage.
WARNING. To avoid electrical shock the power cord
protective grounding conductor must be connected to
ground.
AVERISS: Pour éviter les chocs électriques, le fil de terre
du cordon secteur doit impérativement être relié à la
terre.
When line voltages are changed, replace the required fuses shown as below:
Model
Line
voltage
Range
Fuse
Line
voltage
Range
Fuse
PSS-3203
T3A
250V
T1.6A
250V
PSS-2005
100V
120V
90-110V
108-132V
T3A
250V
220V
230V
198-242V
216-253V
1.6A
250V
PSS-3203/2005 PROGRAMMABLE POWER SUPPLY
USER MANUAL
6
WARNING. To avoid personal injury, disconnect the power cord
before removing the fuse holder.
3-3.Environment
The normal ambient temperature range of this instrument is from 0
°
to 40
°
C
(32
°
to 104
°
F). To operate the instrument exceeding this specific
temperature range may cause damage to the circuits of instrument.
Do not use the instrument in a place where strong magnetic or electric field
exists as it may disturb the measurement.