Goodman 0 Installation & Operation Manual

Manual is about: SPLIT TYPE ROOM AIR CONDITIONER AND HEAT PUMP MODELS

Summary of 0

  • Page 1

    Important safety instructions the following symbols and labels are used throughout this manual to indicate immediate or potential safety hazards. It is the owner’s and installer’s responsibility to read and comply with all safety information and instructions accompanying these symbols. Failure to he...

  • Page 2

    2 contents important safety instructions .............................................. 1 shipping inspection ............................................................ 1 codes & regulations ......................................................... 2 installation considerations ......................

  • Page 3

    3 • select a location where noise, vibration and hot dis- charged air will not be an issue. • do not install where high frequency equipment is used (wireless equipment, welding machine, medical facility) as it may interfere with the unit’s operation. Rooftop installations if it is necessary to insta...

  • Page 4

    4 note: install the mounting bracket and drill the holes in the wall according to the wall structure and the correspond- ing mounting points on the mounting bracket. (the mounting brackets vary according to the model.) incorrect orientation of installation plate correct orientation of installation p...

  • Page 5

    5 indoor unit installation 9. Pass the piping through the hole in the wall. 10. Place the upper claw on the back of the indoor unit on the upper hook of the installation plate. Move the indoor unit from side to side to ensure it is securely mounted. (see figure 10 ). Note: by placing cushioning mate...

  • Page 6

    6 1 h figure 14a 2 w 1 w 2 figure 14b ms* 9 & ms*12 outdoor unit dimensions inches/mm (l1xhxw1) l2 (mm) w2 (mm) 30" x 23" x 11" 760 x 590 x 285 21" 530 11 1/2" 290 mounting dimensions drain joint installation note: drain joints differ slightly according to the different outdoor units. Inspect your u...

  • Page 7

    7 2. Insert tube in flare tool to measurement “a” in chart. Flare tubing as shown in figure 19. Make sure flare is free of burrs and completely formed to make a leak proof joint. Note: in order to avoid dropping burrs into the tubing, angle the end of the copper tube/pipe in a downward direction as ...

  • Page 8

    8 important notes: • if there are safety issues concerning the power supply, the unit should not be connected until safety issues are resolved. • ensure that the electrical power supply is sufficient to safely power and run the unit. • power voltage should range for 90% - 110% of the rated voltage. ...

  • Page 9

    9 terminals on the indoor unit l n s l n s model a terminals on the indoor unit l n s terminals on the outdoor unit 1(l) 2(n) s l n power supply model b 3. Secure the wire onto the control board with the cord clamp. 4. To prevent the ingress of water, form a loop of the con- nective wires as illustr...

  • Page 10: Warning

    10 • when relocating the unit to another place, perform the evacuation using a vacuum pump. • refrigerant added to the unit must be in liquid form. (does not apply to units using r-22.) safe refrigerant handling while these items will not cover every conceivable situation, they should serve as a use...

  • Page 11

    11 test running after completing the gas leak check at the flare nut connec- tions and electrical safety check, perform the test operation. • ensure all tubing and wiring have been properly con- nected. • make sure both the gas and liquid side service valves are fully open. 1. Connect the power; pre...

  • Page 12

    12 goodman manufacturing company, l.P. 5151 san felipe, suite 500, houston, tx 77056 www.Goodmanmfg.Com © 2011 goodman manufacturing company, l.P..