Summary of EG1400
Page 1
Electric powerhead owners manual p/n 9476.
Page 3: Warning:
Important safety instructions read these instructions before using this electric powerhead warning: to reduce the risk of fire, electrical shock or injury: • unplug and disconnect power before servicing. • do not use on wet surfaces. • do not allow to be used as a toy. Close attention is necessary w...
Page 4: Parts & Features
Parts & features it is important to know your vacuum cleaner’s parts and features to assure its proper and safe use. Review these before using your cleaner. Warning always unplug the eg1400 before cleaning the brush area as brush may suddenly restart. Failure to do so can result in personal injury..
Page 5: Assembly Instructions
Assembly instructions warning! Do not plug into electrical supply until assembly is complete. Failure to do so could result in electrical shock or injury. 1. Slide wands together until wand button 1 snaps into place. Turn wand button 1 to the slotted area of the wand swivel. (fig. A) the swivel allo...
Page 6: General Operation
General operation • the eg1400 is controlled by the on/off power control switch located on the hose handle. The headlight will operate when the eg1400 is turned on. • to lower wand from the upright position, simply press on the handle release pedal. • the powerhead has a pile height pedal for variou...
Page 7: Performance Features
Performance features edge cleaner active brush edge cleaners are on both sides of the eg1400. Guide either side of the eg1400 along baseboards or next to furniture to help remove dirt trapped at carpet edges. Overload protector the eg1400 has built-in protection against motor and belt damage should ...
Page 8: Maintenance and Care
Maintenance and care warning!!! Disconnect electrical supply before servicing or cleaning the unit. Failure to do so could result in electrical shock or personal injury from cleaner suddenly starting. Always follow all safety precautions specified when caring for your eg1400. To remove belt 1. Turn ...
Page 9: Maintenance and Care
Maintenance and care to replace belt: 1. Install new belt (part # 9439-01) over motor drive then over belt path. (fig. L) 2. Place agitator assembly back into eg1400. (fig. M) 3. Reinstall agitator cover by lining up the front tabs and slots and rotating downward until the latches snap into place. (...
Page 10
Eg1400 explosion & parts list.
Page 11
Illustration # h-p part # description 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 42 43 44 45 47 50 51 52 53 54 55 56 7925 8438 9439-01 7962 9440 9441 7959 7941 7967 9442 7940 7929 9443 7966 7930 9444 7928 7969 7946 9445 7963 9446 9447 9448 7972 9449 9450 945...
Page 12
H-p products, inc. 512 w. Gorgas street louisville, oh 44641 www.Centralvacservice.Com limited warranty h-p products, inc. Warrants that the eg1400 electric powerhead, when used for household purposes, pursuant to seller’s instructions, will be free from defects in materials and workrkmanship for a ...