H2O Audio Capture Product Manual
Double Your Warranty Offer
If you register your product online at www.h2oaudio.com/productregistration we’ll double
your warranty from 1 year to 2 years.
Return Authorization
Prior to any return, a Return Authorization (RA) number must be obtained. To receive an
RA number, go online to www.h2oaudio.com/ra and follow the instructions on how to
return a product. Proof of purchase from an Authorized Dealer will be required.
Copyright Notice:
This owner’s manual is copyrighted, all rights reserved. It may not,
in whole or in part, be copied, photocopied, reproduced, translated, or formed into any
electronic format without prior consent in writing. H2O Audio is a registered trademark
of H2O Audio, Inc. Apple, iPod and iPod nano are trademarks of Apple Inc., registered
in the U.S. and other countries. Apple is not responsible for the operation of this device
or its compliance with safety and regulatory standards. H2O Audio products are
protected by US Patents 6396769, 6614722, 6954405, 7263032, 7535799 and Others
Pending.
Warranty Coverage
H2O Audio guarantees, to the original purchaser only, that the equipment purchased is
free of defects in material and/or workmanship under normal recreational use for a period
of one year (1) from date of consumer purchase from an Authorized Dealer; provided that
proper care and maintenance have been performed as prescribed by the owner's guide
included with the equipment. Should this product prove to be defective for any reason
(other than those listed as limitations below) the product will be serviced or replaced at
H2O Audio's sole discretion at no charge (excluding shipping and handling). This warranty
shall be void if the equipment has been tampered with by anyone not authorized to
perform service. The warranty is non-transferable and extends to the original purchaser
only and is valid only if the equipment was purchased from an Authorized Dealer. Warranty
does not extend to cover damage from accident, abuse, tampering, lack of maintenance,
theft, or loss. Service or modifications by anyone other than an Authorized H2O Audio
agent will void the warranty. H2O Audio will not be responsible for recovery or
replacement of the product in the event of loss or theft. H2O Audio, its Authorized
International Distributors, and Authorized Dealers make no other warranties, either
express or implied or orally, or in writing, with respect to any other warranty coverage
except those expressly stated within the preceding sentences. H2O Audio will not be held
responsible for any agreements orally or in writing with the exception of those expressly
included in this warranty statement. The warranty registration and the terms contained
herein supersede all statements contained in any and all owner's guides, instruction cards,
or other equipment literature or catalogs. In no event will H2O Audio, its Authorized
International Distributors, and Authorized Dealers be held responsible or liable for any
personal injuries resulting from the use of the covered equipment, or for any other
damages, whether direct, indirect, incidental, or consequential; even if H2O Audio has
been advised of such damages.
Safety Information
Please read this manual carefully. If you have any questions please contact H2O Audio
Customer Service prior to use.
Improper use of this system may cause the user to make mistakes or decisions that may lead
to serious injury or death.
Always make sure to have the audio player volume turned to zero and the headphones
turned away from the ears when turning on the audio player. If the volume level is not
zero when the audio player is turned on, it may cause ear injury due to a sudden burst of
volume. The volume should be slowly increased with an audio track playing to set the
speaker volume to comfortable output levels prior to positioning the headphones next to
the ears. Hearing experts advise against continuously loud and extended play. If you
experience ringing in your ears, reduce volume or discontinue use.
It can be potentially dangerous to use headphones while engaging in activities that require
your full attention. You should exercise extreme caution or discontinue use in potentially
hazardous situations. Do not use the headphones while driving, cycling, or operating any
motorized vehicle. It may create a traffic hazard and is illegal in some areas. Those users
that elect to utilize this system at, or near, the water’s surface, must maintain safety
awareness of moving water crafts
WARNING: Contains small parts which may be a choking hazard. Not suitable for children
under 3 years old.
FAQs
1. What happens if the waterproof headphones become disconnected from the case?
As long as the case is not submerged under water for long periods of time, it should be
fine. The longer the case is submerged under water, the higher the possibility water can
enter the case through the stereo jack. In an incident that the headphones detach from the
case, we suggest getting that connection back together as soon as possible.
2. What headphones are compatible with H2O Audio Waterproof Cases?
H2O Audio Waterproof Cases are designed to work with H2O Audio Waterproof
Headphones and standard 3.5mm headphones.
The case should not be submerged under water for long periods of time without H2O
Audio Waterproof Headphones plugged in as water may be able to enter the case through
the stereo jack.
3. Can H2O Audio Waterproof Cases be taken into a hot tub or sauna?
Yes. Although users should not take their H2O Audio Waterproof Case into environments
where the temperature fluctuates drastically as internal condensation may form (i.e. from a
cold pool to a hot sauna or hot tub).
NOTE: For more FAQs please visit www.h2oaudio.com/faq
Maintaining Your Waterproof Case
Waterproof Case
Your H2O Audio Capture Waterproof Case is completely waterproof. After in-water use,
rinse your case off with clean water and let it air dry for your next use. Strong detergents,
soaps, and chemicals should never be used to clean the case.
Do not expose the case to extreme heat, such as the inside of a hot car, or in hot direct
sunlight, such as on a beach, or boat deck. Doing so may cause damage and subsequent
flooding.
For long-term storage, store in a plastic bag out of direct sunlight.
Silicone Seal
To clean the silicone seal, remove it from the case and wash with warm fresh water. Strong
detergents, soaps, and chemicals should never be used to clean the silicone seal. Allow seal
to air dry and install back into the case.
The life of the silicone seal is typically one year. A replacement seal has been provided.
Please contact H2O Audio Customer Support for additional seals.
The seal does not require lubrication. Do not use silicone grease to lubricate the seal.
Sport Armband
To clean the Sport Armband, wash gently by hand, with mild detergent. Allow to air dry
our of direct sunlight. Do not tumble dry.
Using the Sport Armband
When using the H2O Audio Capture Waterproof Case on the armband the case should be
attached to the armband leash as shown.
1. Slide the armband leash through the leash hole
on the bottom of the case.
2. Loop armband leash over the SealTight Connector
and stretch around the case.
3. Pull the armband leash tight.
4. Attach case to armband.
Using the Belt Clip
Your H2O Audio Capture Waterproof Case comes with a removable, reversible belt clip and
a neoprene sports armband suitable for most active sports. The belt clip is held in place by
two screws that can be installed using a standard Phillips-head screwdriver.
The belt clip can be reversed to change the access direction of the headphone jack.
Designed for
Connecting Your Headphones
The SealTight Connector™ featured on the H2O Audio Capture Waterproof Case is
designed to create a 100% waterproof connection with H2O Audio Waterproof
Headphones (sold separately).
The case should not be submerged under water for long periods of time without H2O
Audio Waterproof Headphones plugged in as water could enter the case through the
headphone jack.
If your case falls into the water while using standard, non-waterproof headphones, we
suggest you remove it from the water as soon as possible.
2. Insert the headphones into the case
by rotating the plug as it's inserted in
to the Sealtight Connector, this will
remove any air pressure trapped
inside the Sealtight Connector and
ensures a tight connection.
1. Align the headphone plug with the
Sealtight Connector.
Menu Button
Select Button
Next/Fast-Forward Button
Previous/
Rewind Button
Scroll Wheel rotates
Clockwise and
Counter- Clockwise
Play/Pause Button
Controlling Your iPod nano (5th Gen)
The Commander Scroll Wheel™ is a waterproof assembly, which provides complete control
over the click wheel and push buttons featured on your iPod nano (5th Gen).
Waterproof Seal
Checking the Waterproof Seal
The H2O Audio Capture Waterproof Case features a removable, black silicone seal that
forms a waterproof barrier between the base and lid of the case. It is
extremely important that special attention is paid to ensure the
silicone seal is completely seated in the groove of the lid. If the seal
is loose, out of alignment, twisted or pinched in any way, it will
compromise the waterproof integrity of the case and should not
be used. Any debris such as hair or sand will keep it from
forming a watertight barrier and should be cleaned off
before use.
It is extremely important you ensure the seal is clean and
properly seated each time you close the case as failure
to do so may ruin your iPod.
Caution: If the seal comes out of alignment,
carefully place it in the groove, ensuring all 4
corners are correctly installed. Compress the lid
to the base and then re-open it to make sure
the seal is fitted correctly into the groove.
The seal should appear straight and
uniform along it’s’ edge and should
not fall out easily.
If you have any concerns please
contact H2O Audio Customer
Support.
2. While holding the latch button
towards the unlock icon, push the
top of the latch away from the case.
5. Align the headphone jack with the stereo
plug inside the case and slide iPod into place.
1. Slide latch button towards the
unlock icon.
4. Ensure the nano’s hold switch
is not enabled.
7. Pull the top of the
latch toward the case
and snap closed. The
latch button should
automatically move to
the lock icon.
8. Verify the latch is closed and locked and the seal is
aligned correctly.
Important: Remove any skins or
covers from your nano before
installing into the case.
3. Unhook latch from the back of
the case.
6. Close the lid and hook the latch
onto the back of the case.
Installing the iPod nano (5th Gen)
Introduction
The H2O Audio Capture Waterproof Case
TM
allows you to utilize all of your favorite iPod
nano (5th Gen) features including music playback and video recording, in, around, and
under water.
Using Your Waterproof Case the First Time
Before using your H2O Audio Capture Waterproof Case for the first time, it is highly
recommended that you become familiar with opening and closing the case to ensure it is
sealed properly during use. To verify that you have sealed the case properly we recommend
that you test the product without an iPod nano (5th Gen) inside before initial use. Please
follow the instructions below.
1. Open the case and verify the seal area is clean and free of debris or damage.
2. Close and lock the case without the iPod nano (5th Gen) inside.
3. Attach H2O Audio Waterproof Headphones (sold separately).
4. Submerge the system in water and soak for 30 min.
5. Manipulate the scroll wheel and push button controls during submersion.
6. Remove from water and dry exterior so water does not fall inside when opened.
7. Open the case and ensure there is no water inside.
Do not use if water is found inside the case.
Please contact H2O Audio Customer Support immediately.
LatchTight
Locking Closure
TM
Display Window
Removable/
Reversible Belt Clip
Polycarbonate Lens
Commander
Scroll Wheel
TM
Sealtight Connector
TM
www.h2oaudio.com
Customer Support:
Monday - Friday 9AM to 5PM PT
www.h2oaudio.com
P. 800-708-6080 or 858-623-0339
F. 858-225-0815
E. support@h2oaudio.com
W a t e r p r o o f C a s e
T M