Summary of iDive300
Page 2
D e e p d i v e w a t e r p r o o f c a s e & s p e a k e r s d e p t h r a t i n g 3 0 0 f t / 9 0 m idv1-75 20080819 for updated manuals please visit our web site www.H2oaudio.Com w w w . H 2 o a u d i o . C o m.
Page 3
Depth rating 300ft / 90m cam knob lock cam knob mask clip speaker led lights lanyard hole ipod ® control buttons connector cable battery cover insert holes & height adjuster holes o-ring 1 2.
Page 4
Quickstart: instructions: i. Read “getting familiar with the idive 300” ii. Unlock and open case iii. Install batteries (3 aa) iv. Install ipod specifi c inserts and height adjusters (see page 10 for fi t chart) v. Install ipod vi. Turn on ipod vii. Close and lock case viii. Press and hold the power...
Page 5
Prior to use verify: 1. The o-ring is lightly lubricated and seated within the track in the lid. 2. The o-ring and contact surface are free of scratches and other imperfections. Do not use if: 1. The o-ring is dry, cracked, twisted, and/or out of alignment. 2. O-ring and/or contact surfaces have any...
Page 6
To close case 1. Close lid 2. Rotate the cam knob clockwise 180° 3. Close the cam knob lock iv. Install batteries 1. Open case. 2. Disconnect and remove ipod from case if installed. 3. Turn the battery cover screw counter-clockwise until the screw loses contact with the insert plate. 4. Remove batte...
Page 7
Included insert and height adjusters inserts and height adjusters are labeled to aid identifi cation. As new ipods become available please check our web site for updates on inserts and height adjusters. Insert and height adjuster reference ipod touch iphone & iphone 3g ipod nano 1 st gen ipod nano 2...
Page 8
Vi. Insert ipod 1. Ensure the correct inserts and height adjusters are installed for your ipod (please note: if the correct insert and height adjusters are not used you may damage or destroy your ipod and the idive300) 2. Place ipod in the inserts with the ipod dock connector facing toward the cam k...
Page 9
In case of a steady red led 1. Ensure you are using a supported ipod model. 2. Ensure the ipod is fully charged. 3. Ensure the ipod is turned on. 4. Disconnect & reconnect the connector cable. In case of a flashing red led 1. Batteries of the idive300 case are running low – change or recharge them s...
Page 10
Caution: do not store case in the following environments: * solvents or other chemical fumes * high humidity * high ozone * extreme temperature fl uctuations storing the case in these conditions may lead to a damaged case, causing it to leak. Rinse the exterior of the system in fresh water after eac...
Page 11
Improper use of this system may cause the user to make mistakes or decisions that may lead to serious injury or death. Important warning and disclosure: any individual intending to utilize this product during s.C.U.B.A diving activities must be properly trained and certifi ed by an accredited agency...
Page 12
To obtain service: please go to support section of our website or contact customer support at customer support hours and contact information: monday through friday 9am to 5pm pt tel: 858.623.0339 toll free: 800-708-6080 support@h2oaudio.Com please note: no service returns will be accepted without a ...
Page 13
Q: why is the red led fl ashing? A: the idive300 is designed to measure battery-life of the 3-aa batteries that are used to power the “made for ipod” connection electronics and the power amplifi er. The red led will start to fl ash when the batteries have approximately 25% charge remaining. Note, th...
Page 14
W w w . H 2 o a u d i o . C o m copyright notice: this owner’s manual is copyrighted, all rights reserved. It may not, in whole or in part, be copied, photocopied, reproduced, translated, or formed into any electronic format without prior consent in writing. H2o audio is a registered trademark of h2...