Haan Complete MS-35 Instruction Manual - page 17
Using the Attachments:
(cont)
on pg 11-12, steps 11-13). Be careful not to
over-fill the tank.
3) Plug the product into a grounded plug and press
the ON/OFF switch to start the heat cycle. The
GREEN Power ON light and the ORANGE READY
Light will illuminate. It takes approximately 3-5
minutes for the Commercial to heat up and
generate steam. The READY light will deactivate
once the unit is ready to begin.
4) To attach the Carpet Glide, place the front of the
steam head under the tabs on the front of the
Carpet Glide and press down. The tray is made to
fit snuggly and will snap easily into place.
(Fig 14)
5) Push and pull the Steam Head slowly
across your carpet to thoroughly steam clean
and sanitize each section (Fig. 15).
6) When you have finished using the unit, turn it
OFF, place it on the Floor Protector Mat and wait
until the unit cools down (approximately 5 minutes).
Remove the Carpet Glide by using your foot
to hold the rear tab and then while holding the
tray with your foot, lift the unit off the tray.
The Carpet Glide will snap OFF easily as it
is designed for this No Touch method of removal
(Fig 16).
7) Store the attachment in a cool, dry area with the
other attachments.
Helpful HAAN
®
Hint :
Lifting Fresh Stains
While using the HAAN
®
Commercial with the
Carpet Glide will not lift all set-in stains from
your carpet, our patented Ultra-Microfiber Pads
may be used to act as a “blotter” for removing
most fresh, wet spills and stains.
To remove a stain, attach the Carpet Glide to the
Steam Head and heat the unit as described above.
Place the Steam Head over the stain and hold it in
place for a few seconds to allow the steam to
penetrate the area of the stain. Push and pull the
Steam Head slowly across the stained area to
work the steam into the stain.
Fig 14
Fig 15
Using Your Product
Fig 16
Front
Tabs
Foot Tab
!
i
CAUTION
The product emits steam at
212˚F to sanitize the area
of use. This means that
the steam head, Ultra-
MicroFiber Pads and
attachments get very hot
during use. Care should
be taken when using this
appliance and DO NOT touch
them during use except in
the approved manner as
outlined in this manual.
Using Your Product
Fig 41
Using the Attachments:
(cont)
To attach and use accessories: (cont)
6) Push the attachment of choice onto the end of
the Concentrator Nozzle until it is firmly attached.
It will be a tight fit. The end of the nozzle is
shaped to fit the interior of each attachment
snuggly and you can change their position
around the nozzle to reach exactly the spot you
need to focus the steam (Fig 40).
7) Each of the small accessories (Angled Nozzle,
small round brushes, and the large Round Brush
attachment with, or without the steel wool) fit
onto the end of the Concentrator Nozzle in the
same way to concentrate your celaning with steam.
MicroFiber Towel & Sponge:
With the cleaning power of our Ultra-Microfiber on
one side and the super absorbency of our specially-
developed chamois on the other, these make clean-
quick and easy. Use the steam to clean and sanitize
surface areas and wipe any excess moisture up with
either the towel or sponge (Fig 41).
Garment/ Flat Surface attachment and Ultra-Microfiber
Cleaning Sock:
Use the Garment/Flat Surface Attachment alone for
steaming out wrinkles in clothing, sanitizing upholstery,
bedding and soft surfaces (Fig 42).
Attach the Cleaning Sock to the Garment/Flat Surface
Attachment to clean counter tops and other hard
surfaces to provide another means to sanitize kitchens
and bathrooms.
1) Follow the directions for attaching the Garment/
Flat Surface Attachment to the Steam Jet Nozzle
as you would the Concentrator Nozzle from
pg 21, steps 1-4. Be sure to lock the attachment
onto the Steam Jet Nozzle before using it to steam
away wrinkles and sanitize soft surfaces.
2) By attaching the Cleaning Sock the steam will
sanitize flat surfaces and absorb excess moisture
in one swipe.
Fig 40
➟
Shaped
Nozzle
End
Fig 42
!
i
CAUTION
The product emits steam at
212˚F to sanitize the area
of use. The attachments get
very hot during use. Care
should be taken when using
this appliance and DO NOT
touch the attachmants
during use except in the
approved manner as
outlined in this manual.
15
22