Haes Alarm Sense Plus Quick Start Manual - Setup & Programming
ASP-R Quick Start Guide
Approved Document Ref: UI-ASP-R-02 Issue 1.0
5
SETUP & PROGRAMMING
REPEATER PANEL SETUP & PROGRAMMING
The panels can support up to 8 repeaters. The repeater panels are fully functional with ‘Silence’ ‘Resound’
and ‘Reset’ controls, as well as Disable and Test Mode functions. It is possible to disable the controls of
each or all repeater panels to make them passive.
Repeater Comms PCB
To run repeaters, a Comms PCB (TPCA05) must be fi tted to the main control panel. A Comms PCB for the
control panel is supplied, as standard, with each repeater panel. The repeater panels themselves already
have the comms board fi tted.
The Comms PCB fi ts into the control panel on top of the main circuit board where the ribbon cable from
the display board is normally plugged.
To fi t the Comms PCB, power down the panel, un-plug the display board ribbon cable from the main circuit
board and plug the Comms PCB into the socket instead.
A socket is provided on the top of the Comms PCB to re-connect the display board ribbon cable.
PSU
@
+
+
-
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
28V 0V
C
NC NO
C
NC NO
FIRE
FAULT
FR
FLT
CC
PUL
-OP -OP -IP -IP
SNDR1
SNDR2
ZONE1
ZONE2
ZONE3
ZONE4
BATTERY
PSU
@
+
+
-
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
28V 0V
C
NC NO
C
NC NO
FIRE
FAULT
FR
FLT
CC
PUL
-OP -OP -IP -IP
SNDR1
SNDR2
ZONE1
ZONE2
ZONE3
ZONE4
BATTERY
COMS A
COMS B
28
V+
SW -ve OUTPUTS
+
-
+
-
1
2
3
4
5
6
1
2
3
4
ON
ADDRESS
Disconnect display board ribbon cable
7 way DIL switch
Plug Comms PCB into the socket and
re-connect dispay board ribbon cable to
socket on top of Comms PCB
1
2
3
4
5
6
7
ON
1
2
3
4
5
6
7
ON
Addressing
Each repeater panel needs to have a seperate address. The addressing is done using the 4 DIL switches
on each of the Comms PCBs using binary code values, see diagram below.
The address should be set in sequence from 1 - 8, fi rst repeater address 01, next repeater address 02 etc.
Note:- The control panel should always be address 0 (all switches off).
1
2
3
4
ON
ADD 01
1
2
3
4
ON
ADD 02
1
2
3
4
ON
ADD 03
1
2
3
4
ON
ADD 04
1
2
3
4
ON
ADD 05
1
2
3
4
ON
ADD 06
1
2
3
4
ON
ADD 07
1
2
3
4
ON
ADD 08