Hafco HM-32 Operation Manual - page 18
18
OPERATION MANUAL
TOOLMASTER C922B
—3MT Chuck & Collet Set
An affordable quick change collet system with ultra
precision. These spring collets are hardened and
ground to exacting tolerances and offer incredible
holding power. This set includes an 3MT x ER32
collet chuck, spanner wrench, plastic carrying case
and collets sized 7-6mm, 8-7mm, 10-9mm, 13-
12mm, 16-15mm and 20-19mm. These collets can
also be used for imperial sizes. Drawbar size 1/2”
whitworth
The
HM-32
Mill Drill is supplied with some basic tooling. Below is a list of quality tooling
that may be needed to enhance the scope of the machine.
HAFCO C0965
—14MM 52-PC . Clamping Kit
This clamping kit includes 24 studs, six step block
pairs, six T-nuts, six flange nuts, four coupling
nuts, and six end hold-downs. The rack is slotted
so it can be mounted.
ALIGN M230
—Power Feed for Mill Drills
If you want to get the most out of your mill
drill you really need a power feed. This power
feed unit comes with everything required to
start milling with exact control. Comes sup-
plied with easy to assemble mounting bracket,
drive belt and pulley, and auto-stop limit
switch with movable stop.
TM M529
—Carbide Insert Face Mill
This 50mm Face Mill accepts four
carbide inserts (not included). Comes
with an 3MT arbor.
Uses Inserts TPKN1603 (L0661)
Always use
quality
Alcock
Cutters
5.3 OPTIONAL ACCESSORIES
Order Code C933B
Order Code C0965
Order Code M230
Order Code M529
Page 18
Instructions Manual for HM-32 (K012)
07/02/2018