Hafler installation operation please refer to this serial number in all communications regarding this equipment..
Specifications introduction 8 ohm power rating: 325 watts continuous aver- age power per channel at less than .025% total harmonic distortion from 2ohz to 20khz with both channels driven. 4 ohm power rating: 450 watts continuous aver- age power per channel at less than .035% total harmonic distortio...
1. Read instructions aii the safety and operating instructions of your hafler equipment should be read before power is applied to the equipment. 2. Retain instructions these safety and operating instructions should be held for future reference. 3. Heed warnings all warnings on the equipment and in t...
16. Carts and stands the equipment should be used only with a cart or stand of sufficient strength and stability for the use intended. 16a. An equipment and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the equipment and cart combination to t...
Installation mounting the front panel is designed to fit a standard 19” rack at 3- l/ 2” intervals or alternatively the unit may be stacked. Note: when rack mounting the pro5000, the rear of the amplifier must be fastened to the rack via the rear mounting holes to eliminate large torque forces on th...
Are the ‘banana’ plug connectors with 3/4” spacing. Bare wire can be inserted through the vertical holes in the shafts, which are visible when the caps are unscrewed. To be certain that no strands of wire are unsecured, it is best to tin the wire end before insertion. Alternatively, a spade lug sold...
Pro 5000 functional block diagram temperature sensors fan speed control r e l a y / relay timer kickout offset detector output signal d e t e c t o r , l i g h t designator part description t201 transformer db201 diode bridge f201 10a fuse sw201 power switch s w 2 0 2 grounding switch c201, c202 cap...
Pro 5000 parts list designator part description designator: channel channel) part designator part description part c l 9 c20 (c3) (c4) c 2 2 (c5) c 2 3 ( c 6 ) c24 ( c 7 ) c25 (c8) c 2 6 (c9) c 2 7 ( c i d ) c28 c 2 9 (cl2) c30 (cl3) c31 (cl4) c 3 2 (cl5) c 3 3 (cl6) c 3 4 (cl7) c35 (cl8) c 3 7 (c36...
Thermal protection: the pro5000 is equipped with a unique protection system that continually monitors the temperature of the output devices and takes corrective action to prevent damage to the amplifier as a result of overheating. Under most con- ditions, the pro5ooo’s cooling system can dissipate t...
