1. DL manuals
  2. Hager
  3. Door locks
  4. 4200 SVR Exit Device
  5. Installation Instructions Manual

Hager 4200 SVR Exit Device Installation Instructions Manual

Summary of 4200 SVR Exit Device

  • Page 1

    4200 svr exit device installation instructions i-ed01626 rev 1, rev date: 07/29/14 page 1 of 6 vertical centerline single device two vertical rod devices vertical rod and rim device tools and hardware required door handing horizontal centerline =>40mm =>40mm =>40mm ~5mm 4.5~7mm 56mm 18mm 1000mm from...

  • Page 2

    4200 svr exit device installation instructions i-ed01626 rev 1, rev date: 07/29/14 page 2 of 6 box contents fasteners and other parts included qty. Purpose m5 - 0.8 x 25mm round head machine screws 6 mount the device head and end cap to a wood or metal frame. M5 - 0.8 x 35mm sex nut (7.5mm sleeve di...

  • Page 3

    4200 svr exit device installation instructions i-ed01626 rev 1, rev date: 07/29/14 page 3 of 6 1. Prep exit device for door size 1) prep for door width. A. The 4’ exit device will work for openings from widths of 650mm to 1828mm. However, for openings narrower than 1100mm, the device must be cut. B....

  • Page 4

    4200 svr exit device installation instructions i-ed01626 rev 1, rev date: 07/29/14 page 4 of 6 2. Prepare door 1) mark vertical and horizontal centerline ( ℄) for desired setup using the dimensions on page 1 of this instruction set. 2) tape drilling templates #t-ed01672 on the door, using the vertic...

  • Page 5

    4200 svr exit device installation instructions i-ed01626 rev 1, rev date: 07/29/14 page 5 of 6 4) install the top and bottom strike in the locations previously prepared with mounting screws. - install the top strike with just the outer screws at first. Top strike bottom strike 5) install top and bot...

  • Page 6

    4200 svr exit device installation instructions i-ed01626 rev 1, rev date: 07/29/14 page 6 of 6 7) install top rod - screw the top rod onto the top latch bolt until the lower part of the rod can clear the housing slide bar. - unscrew the top rod from the top latch bolt while guiding the lower part of...