1. DL manuals
  2. HAI
  3. Security System
  4. 47A00-1
  5. Installation Instructions Manual

HAI 47A00-1 Installation Instructions Manual

Summary of 47A00-1

  • Page 1

    Document number: 47i00-1, rev b 47a00-1 installation instructions description: the 47a00-1 is a wireless quad pet immune pir (passive infrared) motion detector that works with the hai 45a00-1 wireless receiver. It has a unique automatic power saver (aps) mechanism which enables transmitter activatio...

  • Page 2

    Operation: the 47a00-1 transmits the following event data: supervision: a periodic transmission every 60 minutes to indicate detectors presence. Alarm: alarm transmission triggered by pir intrusion detection. Battery low: whenever the battery reaches a preset low level (2.4v) “battery low” signal wi...

  • Page 3

    Select mounting location: select the mounting location so that an intruder will cross the beams of the selected pattern. As the detector is a wireless transmitter, and in order to take full advantage of the sophisticated operation of the pir, do not install the detector in areas where large metal ob...

  • Page 4

    Note: the back bracket is not preinstalled in case a corner mount is desired. If the back bracket was installed at the factory and a corner mount was desired, the back bracket would need to be removed and 2 holes would then exist. There should never be a hole where insects can enter as they can caus...

  • Page 5

    Lens pattern configuring the detector: the sensitivity adjustment switch is used to set the detector for normal or harsh environmental conditions. Setting the sensitivity adjustment (pulse width) jumper • position 1= normal • position auto = harsh the “1” position setting is for normal operation. Th...

  • Page 6

    Battery: a 3 v lithium battery powers the unit. Thanks to the exclusive aps (automatic power saver) characteristics, the battery provides about 4 years of continuous operation (depending on the amount of alarms). If the battery reaches a factory preset low level, the “battery low” signal will be sen...

  • Page 7

    Technical specifications: data protocol: hai modulation type: ask event transmission: alarm, tamper (cover off), test, supervision, and battery low supervision timing: 60 minutes detection method: quad element detection speed: 0.3 ~ 1.5 m/sec lens type: spherical hard lens detection coverage: 90.5 (...