Haicom HI-701 BT User Manual

Manual is about: 4 in 1 car holder

Summary of HI-701 BT

  • Page 1

    Bluetooth ® gps enable car holder 4 in 1 hi-701 bt bluetooth ® gps user manual.

  • Page 2: Introduction:

    Introduction: hi-701 bt 4 in 1 car holder is a complete pda car holder solution with the following functions: 1. Charging and supply power to the pda 2. Amplifying the pda sound 3. Making the pda as a gps or bluetooth ® gps enable unit 4. Holding the pda in car by changing the pda base connector on ...

  • Page 3: Accessories:

    Accessories: standard accessories: 1. Hi-701 bt 4 in 1 car holder 2. Pda base connector (one type) 3. Dc 12v cigarette lighter power cable (compatible from dc12v to dc24v) 4. Hinged bluetooth ® gps receiver back card 5. Audio cable 6. Suction cup car mount 1 2 2 2.

  • Page 4

    3 4 5 6 3 3.

  • Page 5: Optional Accessories:

    Optional accessories: 1. Different type of pda base connector 2. Cf slot back card 3. Ps/ii gps receiver 4. External antenna (for hinged gps receiver back card) 5. Mini1394 to ps/ii connecting cable 2 1 4 4.

  • Page 6

    5 4 3 5 5.

  • Page 7: Installations:

    Lock unlock installations: gps receiver installation: slide the inclusive bluetooth ® gps receiver into the back of the car holder so that the pcb golden finger insert and contact properly into the female connector inside. Based on the most powerful and recent sirf stariii ultra high sensitive gps r...

  • Page 8: Led Indicator (

    Bt / gps led indicator led off led flashing led stay on bluetooth ® switch off bluetooth ® searching bluetooth ® connected led indicator ( blue ) 7 7.

  • Page 9: Gps Receiver

    Gps receiver specification chipset interfaces protocol baud rate max. Update rate datum channel frequency hot start warm start cold start reacquisition tike position accuracy macimum altitude maximum velocity voltage power consumption antenna type external antenna connector dimension led indicator s...

  • Page 10: Specifications:

    Specifications: v1.1 compliances frequency range: interface: receiver sensetivity: transmitting power: rf input impedance: frequency hopping: baseband crystal osc: data rate: operating temperature: storage temperature: transmitting range: power consumption: 2.4 ~ 2.4835 ghz unlicensed ism band usb/u...

  • Page 11: Pda Base Connector

    Pda base connector installation: insert the base connector in the front-lower part of the car holder. Make sure the pda base connector is compatible to the pda that you using. 10 10

  • Page 12: Power Up:

    Goose neck to the holder installation: place the top of the goose neck to the back of the holder and push up for fixing. Suction cup support installation: power up: connect the inclusive power cable one end to the car cigarette lighter and another end to the holder lower-left side's connector jack. ...

  • Page 13: Install Your Pda

    Install your pda editor's note: do you need to turn off car ignition to insert pda? Caution: turn off the car's ignition before proceeding. When installed in haicom 4 in 1 car holder, the battery in your pda is recharged. Refer to the following to insert your pda into the cradle: 1. Align the pda's ...

  • Page 14: Removing Your Pda

    Removing your pda refer to the following to remove your pda from the cradle: 1. Push the release button (a) on the side of the cradle to release the padded arms. 2. Lift the pda straight up to remove it. Caution: do not twist the pda as this can cause permanent damage to the connector and/or your pd...

  • Page 15: Connecting To The Pda

    Connecting to the pda you can connect the supplied audio cable from your pda to the to avail of the haicom 4 in 1 car holder's built-in speaker. You can connect a gps antenna to the haicom 4 in 1 car holder if you have a gps-enabled pda. 1. Connect the supplied audio cable to the haicom 4 in 1 car h...

  • Page 16

    A c b important safety notice: most gps software has built-in voice navigation to allow you to keep your eyes on the road while driving. If you need to study the map on your pda, stop the car and pull into the side of the road first. 15 15.

  • Page 17

    Vcc 3.3v tx rx gnd nc nc gps connector pin assignment ensure the ps2 connector for your gps receiver conforms to the pin assignments shown below. The connector is a 6-pin mini-din (male) with 3.6 ± 0.1mm wire. Hinge gps back card pin assignment color green white red black function tx rx vcc gnd cn1 ...

  • Page 18: Hinged Bluetooth

    Hinged bluetooth ® gps receiver back card as a gps mouse: by connecting different optional connecting cables, the hinge gps receiver back card can be all kinds of independent wired gps receiver solutions. 17 17.

  • Page 19: Laptop Pc Installations

    Get connected; installation guide laptop pc installations run "my bluetooth ® places" and double click the "find bluetooth ® devices" icon double click "bt gps" double click "spp on bt gps" 18 18.

  • Page 20: Pda Installations

    Key in pin code: “0000” connected pda installations double click the icon bluetooth ® 19 19.

  • Page 21

    Double click “bt gps” key in pin code: “0000” found the host device 20 20

  • Page 22

    For connected with device select the correct com port start gps, nmea message inflow more satellites info 21 21.

  • Page 23: Gps Technical Data

    Gps technical data one-pulse-per-second (1pps) output the one-pulse-per-second output is provided for applications requiring precise timing measurements. The output pulse is 1usec in duration. Rising edge of the output pulse is accurate to +/-1usec with respect to the start of each gps second. Accur...

  • Page 24

    Software interface this section describes the details of the serial port commands through which the gps module is controlled and monitored. The serial port commands allow users to set the receiver parameters, configure output message type, and retrieve status information. The baud rate and protocol ...

  • Page 25

    Nmea messages the serial interface protocol is based on the national marine electronics association's nmea 0183 ascii interface specification. This standard is fully define in "nmea 0183, version 3.01" the standard may be obtained from nmea, www.Nmea.Org gga - gps fix data time, position and positio...

  • Page 26

    Note: the checksum field starts with a '*' and consists of 2 characters representing a hex number. The checksum is the exclusive or of all characters between '$' and '*'. Field 1 2 3 4 5 6 7 8 9 10 11 12 13 example 104549.04 2447.2038 n 12100.4990 e 1 06 01.7 00078.8 0016.3 5c description utc time i...

  • Page 27

    Gll - latitude and longitude, with time of position fix and status latitude and longitude of current position, time, and status. Format: $gpgll,,,,,,,* example: $gpgll,2447.2073,n,12100.5022,e,104548.04,a, a*65 field 1 2 3 4 5 6 7 8 example 2447.2073 n 12100.5022 e 104548.04 a a 65 description latit...

  • Page 28

    Gsa - gps dop and active satellites gps receiver operating mode, satellites used for navigation, and dop values. Format: $gpgsa,,,,,,,,,,, ,,,,,,* example: $gpgsa,a,3,26,21,,,09,17,,,,,,,10.8,02.1,10.6*07 field 1 2 3 4 5 6 7 example a 3 26,21,,,09, 17,,,,,, 10.8 02.1 10.6 07 description mode, 'm' = ...

  • Page 29

    Gsv - gps satellite in view number of satellites in view, prn number, elevation angle, azimuth angle, and c/no. Only up to four satellite details are transmitted per message. Additional satellite in view information is sent in subsequent gsv messages. Format: $gpgsv,,,,,,,, ... , ,,, * example: $gpg...

  • Page 30

    Rmc - recommanded minimum specific gps/transit data time, date, position, course and speed data. Format: $gprmc,,,,,,,,,,, ,* example: $gprmc,104549.04,a,2447.2038,n,12100.4990,e, 016.0,221.0,250304,003.3,w,a*22 field 1 2 3 4 5 6 7 8 9 10 11 12 13 example 104549.04 a 2447.2038 n 12100.4990 e 016.0 2...

  • Page 31

    Vtg - course over ground and ground speed velocity is given as course over ground (cog) and speed over ground (sog). Format: gpvtg,,t,,m,,n,,k,* example: $gpvtg,221.0,t,224.3,m,016.0,n,0029.6,k,a*1f field 1 2 3 4 5 6 example 221.0 224.3 016.0 0029.6 a 1f description true course over ground, 000.0 ~ ...

  • Page 32

    Pda speaker output plug holder speaker output plug to 12v dc cigarette lighter to ps/ii gps receiver.