- DL manuals
- Haier
- Air Conditioner
- 1050
- Operation Manual
Haier 1050 Operation Manual
Summary of 1050
Page 1
No.001050 split type room air conditioner operation manual please read this operation manual before using the air conditioner hsu-09lh13 hsu-12lh13.
Page 2
Before disposing an old air conditioner that goes out of use, please make sure it's inop- erative and safe. Unplug the air conditioner in order to avoid the risk of child entrapment. It must be noticed that air conditioner system contains refrigerants, which require speciali- zed waste disposal. The...
Page 3
Do not obstruct or cover the ventilation grille of the air conditoner.Do not put fingers or any other things into the inlet/outlet and swing louver. Do not allow children to play with the air conditioner.In no case should children be allowed to sit on the outdoor unit. The refrigerating circuit is l...
Page 4
Cautions strict enforcement safety instruction installation warning please read the following safety instructions carefully prior to use. The instructions are classified into two levels, warning and caution according to the seriousness of possible risks and damages as follows. Compliance to the inst...
Page 5
Cautions warning when abnormality such as burnt-small found, immediately stop the operation button and contact sales shop. Off use an exclusive power source with a circuit breaker enforcement connect power supply cord to the outlet completely use the proper voltage do not use power supply cord in a ...
Page 6
1 2 3 4 indoor unit outdoor unit parts and functions 5 outlet connecting piping and electrical wiring inlet drain hose actual inlet grille may vary from the one shown in the manual according to the product purchased display board inlet anion generator vertical flap (use remote controller to adjust u...
Page 7
Parts and functions used to select code a or b with a press,a or b will be displayed on lcd. Please select a without special explanation. 1.Code when the remote controller appears abnormal, use a sharp pointed article to press this button to reset the remote controller normal. 2.Reset used to select...
Page 8
Remove the batteries in case unit won't be in usage for a long period. If there are any display after taking-out, just need to press reset key. Parts and functions clock set when unit is started for the first time and after replacing batteries in remote controller, clock should be adjusted as follow...
Page 9
Operation remote controller 8 sterilize 2.Health anion function air conditioner starts health anion function operation. For twice press, disappears,the operation stops. Brief introduction to health anion fuction the anion generator in the air conditioner can generate a lot of anion effectively balan...
Page 10
Auto operation operation remote controller 9 sterilize about auto operation under the mode of auto operation, air conditioner will automatically select cool or dry operation according to room temperature and setting temperature. 5.Unit stop press on/off button, the unit stops. 1. Unit start press on...
Page 11
Cool operation remote controller 2.Select operation mode press fan button. For each press, fan speed changes as follows: press mode button. For each press, operation mode changes as follows: remote controller: remote controller: then select cool operation press temp. Button every time the button is ...
Page 12
2.Select operation mode press fan button. For each press, fan speed changes as follows: press mode button. For each press, operation mode changes as follows: remote controller: remote controller: then select dry operation press temp. Button every time the button is pressed, temp.Setting increase 1 o...
Page 13
Fan operation 2.Select operation mode press fan button. For each press, fan speed changes as follows: press mode button. For each press, operation mode changes as follows: remote controller: remote controller: then select fan operation 3.Fan speed selection 4.Unit stop about fan operation in fan ope...
Page 14
2.Up and down air flow direction vertical flap pos.1 pos.1 pos.2 pos.3 pos.4 pos.6 pos.1 pos.2 pos.3 pos.4 pos.5 pos.6 pos.2 pos.3 pos.4 pos.5 pos.6 (auto swing) for each press of button, air flow direction on remote controller displays as follows according to different operation modes: remote contr...
Page 15
If the wind speed is high or middle before setting for the sleep, set for lowing the wind speed after sleeping. If it is low wind, no change. 4.Set the wind speed change when sleeping before going to bed, you can simply press the sleep button and unit will operate in sleep mode and bring you a sound...
Page 16
Remote controller timer on/off operation operation hints: after replacing batteries or a power failure happens, time setting should be reset. Remote controller possesses memory function, when use timer mode next time, just press set button after mode selecting if time setting is the same as previous...
Page 17
Remote controller timer on-off operation operation just press timer button several times until timer mode disappears. According to the time setting sequence of timer on or timer off, either start-stop or stop-start can be achieved. Set clock correctly before starting timer operation. 1. After unit s...
Page 18
Operation 19 when the remote controller is manipulated, it gets the system back to the normal operation mode. Emergency and test operation when machine is running in emergency, the set value of temperature and wind speed couldn't be altered; meanwhile, it can't operate for dehumidifying or under tim...
Page 19
For smart use of the air conditioner setting of proper room temperature close doors and windows during operation if the unit is not to be used for a long time, turn off the power supply main switch. Use the timer effectively use the louvers effectively do not block the air inlet or outlet maintenanc...
Page 20
For smart use of the air conditioner warning air filter cleaning open the inlet grille by pulling it upward. Remove the filter. Clean the filter. Attach the filter. Close the inlet grille. Push up the filter's center tab slightly until it is released from the stopper, and remove the filter downward....
Page 21
Maintenance replacement of air purifying filter 1.Open the lnlet grille 2.Detach the standard air filter 3.Detach old air purifying filter detach old air purifying filter 4.Attach old air purifying filter 5.Attach the standard air filter (necessary installation) 6.Close the inlet grille close the gr...
Page 22
To keep your air conditioner in good condition after season. Operate in cooling mode for 2-3 hours. Put off the power supply cord. Take out the batteries from the wireless remote controller. Cleaning the body. To prevent breeding mold or bad smell, be sure to operate at the designated temperature or...
Page 23
Before setting in high season cleaning the standard air filter. Connecting the earthing cable. Do not block the air inlet or outlet. Plug-in caution caution after brush away dust at the plug, insert the plug of the power supply cord into the outlet completely.In case of suing exclusive circuit break...
Page 24
Is the air filter dirty? Normally it should be cleaned every 15 days. Are there any obstacles before inlet and outlet? Is temperature set correctly? Are there some doors or windows left open? Is there any direct sunlight through the window during the cooling operation?(use curtain) are there too muc...