Haier AB092ACERA Operation And Installation Manual - Installation Procedures
13
Installation of Outdoor Unit
Selection of installation place
Place strong enough to support unit weight, and will not cause vibration and noise.
Place where discharged wind and noise do not cause nuisance to the neighbors, and is sufficiently
ventilated.
Place where is less affected by rain or direct sunlight and sea breeze.
Place with enough space for smooth air flow.
The unit cannot be installed on an unspecified metal frame (e.g. theft guard net).
It shall be not less than 2.5m high from the ground if the outdoor unit is installed close to a street.
Easy for maintenance.
Fixing the unit
Fix outdoor unit bracket to the wall using anchor bolt (M10).
Fasten the outdoor unit onto the installation bracket with bolt (M10) and nut ,and keep it horizontal.
If installation on the wall or on top of a roof, bracket shoukd be fixed securely to resist earthquake or
storms.
Be sure to use rubber pad during installation against unit vibration.
Install the unit in such a way that the angle of inclination is lees than 3 degrees.
Installation dimension of outdoor unit (mm)
113.5
583
319.5
113.5
AU182AFERA