- DL manuals
- Haier
- Air Conditioner
- AB094FAAHA
- Operating & Installation Manual
Haier AB094FAAHA Operating & Installation Manual
Summary of AB094FAAHA
Page 1
Please read this operation manual before using the air conditioner. No.0010576722a indoor unit operation & installation manual cassette type air conditioner please keep this manual carefully and safely. Ab094faaha ab124faaha ab184fcaha ab244fcaha ab424fcaha ab484fcaha.
Page 2: Contents
Contents cautions ........................................................................................... Part name of the unit........................................................................ Maintenance........................................................................................
Page 3: Cautions
Cautions 1 disposal of the old air conditioner before disposing an old air conditioner that goes out of use, please make sure it's inoperative and safe. Unplug the air conditioner in order to avoid the risk of child entrapment. It must be noticed that air conditioner system contains refrigerants, wh...
Page 4: Cautions
4. The wiring method should be in line with the local wiring standard. 5. The power cable and connecting cable are self-provided. The requirement of the power cable: h05rn-f 3g 1.5mm 2 the requirement of the connecting cable: all the cables shall have got the european authentication certificate. 6. ...
Page 5: Warning!
3 warning! Carefully read the following information in order to operate the airconditioner correctly. Below are listed three kinds of safety cautions and suggestions. Warning! Caution! Incorrect operations may result in injuries or machine damages; in some cases may cause serious consequences. Incor...
Page 6: Cautions!
4 cautions! Conditioner should not be used for any other purpose other than airconditioning. Don't use air-conditioner for any other special purposes, e.G. The preservation and protection of food, animals, plants, pecision apparatus as well as work of art, otherwise the qualities of these stuffs may...
Page 7: Warning !
5 warning ! Caution ! Please ask the dealer or specialist to install, never try by the users themselves. After the installation please be sure of the following conditions. Incorrect installation may cause water leaking, shock and fire hazard. Please call dealer to install the air-conditioner. Air-co...
Page 8: Introduction to Spare Parts
Introduction to spare parts 6 drain hose swing fender refrigerant pipe cable line earthing line air filter outlet suction grill (located in the suction grill) in cooling operation, to discharge the water from inside the room. Discharge unit (built in) (located in the outlet) anti-bacteria filter air...
Page 9: Maintenance
7 3. Dismantle air filter caution! 4. Clean 6. Close inlet grill (a) remove dust with vacuum filter. 5. Install air filter (1) put filter into protruding parts at the top of the inlet grill. (2) connect the two pothooks with inlet grill see 2 [clean inlet grill] 1. Open inlet grill see 1. Connect th...
Page 10: Maintenance
8 3. Take of inlet grill 4. Clean caution! Note when the filter too much dust to spray the special detergent for vent fan or utensils. 5. Install inlet grill 6. Install air filter 7. Close inlet grill [clean outlet and shell] see 3 see "clean air filter" see 1 caution! Don't use gasoline, benzene, d...
Page 11: Maintenance
9 note the inner part of indoor unit must be cleaned. Consult dealer, because clean must be done by technician. In cooling operation, discharging system discharge water in room. 2. 1. Seasonal reserve operate the unit with fan mode on a fair day for about half a day to dry the inside of the unit wel...
Page 12: Trouble Shooting
10 the followings are not malfuncition hua hua trouble shooting water flowing sound is heard when the air conditoner is started, when the compressor starts or stops during operation or when the air conditioner is stopped,it som- etimes sounds bi- bi- or godo-godo. It is the flowing sound of the...
Page 13: Trouble Shooting
11 **? On off trouble shooting air does not blow or the fan speed cannot be changed during drying. In dry mode, when room temperature becomes 2 c higher than temperature setting, unit rill run intermittently at lo speed regardless of fan setting during heating,indoor fan is still running even unit i...
Page 14: When Trouble Happens
12 when trouble happens insufficient cooling or heating the operation controller adjusted as required air filter too dirty ? Horizontal swing louver upward ? (in heat mode) any obstacle exists at the air inlet or outlet? Door or window left opened ? Insufficient cooling any other heat sources in the...
Page 15: When Trouble Happens
13 when trouble happens 1. Error display indoor unit malfunction display code please keep this manual carefully and safely. Outdoor unit malfunction display code when the wire remote controller display e1,can check the outdoor unit control board led1 or outdoor unit malfunction display code to sure ...
Page 16: Customer Need-to-Know
14 customer need-to-know customer need-to-know please install the air conditioner according to the requirements specified in this manual to ensure the air conditioner work well. Be careful not to scratch the surface of the case during moving the air conditioner. Please keep the installation manual f...
Page 17: Installation Procedure
15 a b c d e f installation tools standard accessories 1. Screw driver 2. Hacksaw 3. Drill with a diameter of 60mm 4. Inner hexagon spanner,shifting spanner 5. Spanner (14, 17, 19,24,27mm) 6. Pipe cutter 7. Pipe expander 8. Knife 9. Pincers 10. Leakage detector or soapy water 11. Band tape 12. Scrap...
Page 18: Installation Procedure
16 unit shall be grounded. But grounding shall not be connected to gas pipe water pipe, telephone line. Poor grounding will cause electric shock. Be sure to install a leakage breaker to avoid electric shock. Arrange water drainage according to this manual. Cover pipe with insulation materials in cas...
Page 19: Installation Procedure
(2) ceiling height indoor unit can be installed on ceiling of 2.5-3m in height. (refer to field setting and installation manual of ornament panel.) (3) install suspending bolt. Check if the installation place is strong enough to hold weight. Take necessary measures in case it is not safe. (distance ...
Page 20: Installation Procedure
3. Preparation for the installation (1) position of ceiling opening between unit and suspending bolt. 3 18 ab424fcaha ab484fcaha (2) cut an opening in ceiling for installation if necessary. (when ceiling already exists.) (3) install a suspending bolt. (use a m10 bolt) to support the unit weight, anc...
Page 21: Installation Procedure
19 4. Installation of indoor unit in the case of new ceiling (3) adjust unit to its right position. (refer to preparation for the installation-(1)) (4) check unit's horizontal level. Water pump and flating switch is installed inside indoor unit, check four corners of the unit for its level using hor...
Page 22: Installation Procedure
6. Installation of water drainage pipe ( as for outdoor piping, please refer to installation manual of outdoor unit. ) 5. Refrigerant piping outdoor is precharged with refrigerant. Be sure to see the fig.1, when connecting and removing piping from unit. For the size of the flare nut, please refer to...
Page 23
7. Installing the decorated board on the body of indoor unit 6 7 21 4 2 2 1 3 as shown in fig. 1, make the wind deflector motor of the decorated board face to the orifice of the indoor unit, and then mount the decorated board onto the body of the indoor unit. Mounting the decorated board: a. Hang te...
Page 24
22 wiring of decorated board a. Connect it to the connector of the wind deflector motor lead on the decorated board (fig. 5); b. Connect it to the receiving terminal of remote control on the decorated board. Side of decorated board side of indoor unit electrical cabinet ab184~484fcaha (different fro...
Page 25
23 mounting air inlet grid and angle covers (1) mounting the air inlet grid: take care not to wind the lead of the wind deflector motor during mounting the air inlet grid. (2)for model ab184-484fcaha units, the angle covers should be mounted on the angles. ¢ tie the thread of the angle cover onto th...
Page 26
24 piping materials & heat insulating materials as to prevent condensation, heat insulating treatment should be performed. The heat insulating treatment for piping should be done respectively. Piping material heat insulating material hard pvc tube vp31.5mm (inner bore) vesicant polythene thickness: ...
Page 27: Installation Procedure
25 installation procedure tubing permissible length & height difference please refer to the attached manual of outdoor units. Tubing materials & specifications refrigerant filling amount add the refrigerant according to the installation instruction of outdoor unit. The addition of r22 refrigerant mu...
Page 28
Ab094faaha ab124faaha ab184faaha ab244faaha ab424faaha ab484faaha au52lfiaha electrical wiring c1 c2 r r c1 c2 r s t n l m 1 l m 2 n o t e : 1 : l ( b l a c k ) 2 : n ( w h i t e ) 3 : c ( r e d ) - - - - i t ' s n o u s e f o r b u i l t i n e e v ty p e o n t h e i n d o o r u n i t . U v w cm com...
Page 29
Matrix of the dial switch and indoor unit number field setting field setting the unit number indoor unit number setting indoor unit number setting switch and confirmation of the settings. There is a 4-position dial switch for setting the indoor unit number and fan speed level on the computer board o...
Page 30
Item to the checked pay special care to the following and check after installation unproper installation may cause check is gas leakage check performed? Is unit properly insulated? Is water drainage smooth? Is power voltage meet that stipulated on the nameplate? Is wiring and piping correctly arrang...
Page 31
Heating capacity 710*440*270 710*440*270 840*840*240 840*840*240 860*500*60 860*500*60 950*950*80 950*950*80 42db(a) 37db(a) heating capacity 950*950*80 950*950*80 6.35/12.7 6.35/12.7 9.52/15.88 9.52/15.88 9.52/19.05 9.52/19.05 29 cooling capacity model power supply 7200w 8000w 1ph.220v~,60hz 28kg 1...