Haier AC092ACBHA Operation And Installation Manual - Cleaning and Care

7

Cleaning and Care

CAUTION!

Before cleaning the air conditioner ,be sure to turn it off and disconnect

the Power Supply Cord.

Be sure the Intake Grill is installed securely.

When removing and replacing the air filters, be sure not to touch the heat

exchanger, as personal injury may  result.

Cleaning the Air Filter

Open the Intake Grill

1. Pull out both sides and the center of the

    Intake Grill.

2. Pull the Air Filters upward to remove

    them.

3. Clean the Air Filters.

5. Push in both sides and the center of the

    Intake Grill.

4. Re-attach the Air Filters to the Intake Grill.

Push the Air Filter handles away from the

Intake Grille in direction as illustrated, then

pull out Air Filters.

Remove the dust from the Air Filters by

vacuum cleaner or washing them. After

washing, allow the Air Filters to dry

thoroughly in an area protected from sunlight.

1

2

3

The Filters fit onto the inside of the intake

Grill. (figure 1)

The bottom edges of the Air Filters should

fit into the filter brackets. (figure 1)

The Air Filters should be pushed down so

that their top edges fit under the projections

at the top of the Intake Grill. (figure 2)

Dust can be cleaned from the Air Filter

either with a vacuum cleaner, or by washing

the filter in a solution of mild detergent and

warm water. If you wash the filter, be sure

to allow it to dry thoroughly in a shady

place before reinstalling.

If dirt is allowed to accumulate on the Air

Filter, air flow will be reduced, lowering

operating efficiency and increasing noise.

During periods of normal use, the Air

Filters should be cleaned every two weeks.

(Figure 1)

Filter bracket

Air Filter

(Figure 2)

Handle

Air Filter

Bracket

Base

About 30 mm

Arm

Intake Grill

Arm

Notch

Hook

Side Panel