Haier AP282ACAEA Operation And Installation Manual - Manual Operation
Manual Operation
Remote controller operation
11
Operation
Timer ON-OFF Function
Set clock correctly before starting TIMER operation
1.Unit start
After unit start, select your desired operation mode (operation
mode will be displayed on LCD)
2.TIMER mode selection
Press TIMER button on the remote controller to change TIMER
mode. Every time the button is pressed, display of TIMER mode
changes as follows:
OFF
3.Time setting for TIMER ON
4.Timer confirming for TIMER ON
After setting correct time, press TIMER button to confirm time.
Now
5.Timer setting for TIMER OFF
Press time buttons and follow the same procedures in " Time setting for TIMER ON"
Press time button
ON
stops to flash, while
starts flashing.
Time displayed : unit starts at X hour X min.
6.Time confirming for TIMER OFF
After time setting, press SET button to confirm time. stops to flash. Time displayed:
unit starts at X hour X min.
7.Canel TIMER mode
Just press TIMER button several times until TIMER mode disappears.
According to the time setting sequence of TIMER ON and TIMER OFF, either start-stops or
stops-start can be realized.
If the time setting of TIMER ON is the same as TIMER OFF, TIMER ON-OFF function cannot
be set.
ON
Then select TIMER ON-OFF mode.
will flash.
Every time the button is pressed, time increases 10 minuts.
If the button is kept pressed, time will changes quickly.
Every time the button is pressed, time decreases 10 minuts.
If the button is kept pressed ,time will changes quickly.
It can be adjusted within 24 hours at will.
AM refers to morning and PM refers to afternoon.
OFF
AM
:
TIMER
CLOCK
SET
TIME
TIME
SLEEP
LOW MED HIGH
ROOM
TEMP
TEMP
TEMP
SWING
MODE
FAN SPEED
ON
OFF
:
1
3
4
6
2
TIMER ON
AM
TIMER OFF
AM
5
C
FRESH
HIGH/SO
TIMER
SET
FILTER
A
HEALTH
RESET
LOCK
SLEEP
FAN
TEMP
ON
OFF
SWING
MODE
CLOCK
CODE
LIGHT
OFF
1
3
6
5
4
2
ON
OFF
ON
OFF
AM
12:00
AM
12:00
PM
12:00
PM
12:00
TIMER ON TIMER OFF
TIMER ON-OFF
blank