Haier AS072XCEAA Operation & Installation Manual - Instructions to Installation
5. Method for Cutting and Expanding Pipes.
14
Correct
Not Correct
cracks on expanded mouth
burr
incomplete
too long
Tilting
6. When the mounting plate is first fixed
1. Carry out, based on the neighboring pillars or lintels, a proper leveling for the plate to be fixed against
the wall, then temporarily fasten the plate with one steel nail.
2. Make sure once more the proper level of the plate, by hanging a thread with a weight from the central
top of the plate, then fasten securely the plate with the attachment steel nail.
When the pipe is too long or the mouth is damaged, the pipe needs to cut or expanded.
1.cutting hose
2.Removing burr
3.Put on nut
4.Expand Hose
Hose Expander
A
Expansion Size
Hose dia.
Size (mm)A
0.8-1.5
1.0-1.5
6.35 mm(1/4)
9.52 mm(3/8)
80
60mm
2~5mm
Install the indoor unit where there is no T.V set, radio set, and wireless applian ce underneath, and the
sunlight lamp is over one meter away.
If the remote controller is installed on the wall, the indoor unit shall be ensured to receive the signal
while the sunlight lamp is on.
4. Choose the installation place
Install the indoor unit where the weight of the unit can be supported.
Install the indoor unit where the heat source and steam source are not close and the unit inlet and outlet
are not blocked.
Install the indoor unit where the drainage is easy and the outdoor unit can be easily connected.
Install the indoor unit where its cold air and hot air can be easily sent to all the comers of the room.
Install the indoor unit where the power socket is near and there is sufficient space around the indoor unit.
Make a hole of 60mm in diameter, slightly descending to outside the wall.
Install piping hole cover and seal it off with putty after installation.
4. Drawing of pipe Rear piping
Draw pipes and the drain hose, then fasten them with the adhesive tape. Left Left-rear, piping.
In case of left side piping, cut away, with a nipper, the lid for left piping.
In case of left-rear piping, bend the pipes according to the piping direction to the mark of hole for
left-rear piping which is marked on heat insulation materials.
3. Making a Hole on the wall and Fitting the piping Hole cover.