- DL manuals
- Haier
- Dishwasher
- DW12-CBE5
- User Manual
Haier DW12-CBE5 User Manual
Summary of DW12-CBE5
Page 1
0120505371 domestic dishwasher.
Page 2
.1. Gb close-up view (control panel) a b c d e f g h i j "half load" indicator light low rinse aid indicator light low salt indicator light cycle select button cycle indicator light on-off button on-off light delay select button delay indicator light "half load" button safety is a good habit to get ...
Page 3
.2. Gb close-up view (interior) b upper rack d top spray arm c rack height adjustor e lower rack g washing filter i detergent and rinse aid dispenser m third sprayer j salt container cap f bottom spray arm technical characteristics 60 cm 58 cm 82 cm 12 standard place settings 0.03-0.6mpa 220-240v~ 5...
Page 4
.3. Gb salt salt the hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Loadi...
Page 5
Detergent and rinse aid detergent detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "wash cycle table." the detergent dispenser is located on the inside panel the door. ...
Page 6
Loading the dishwasher before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, which re- sults in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked before was...
Page 7
Starting the appliance .6. Gb starting a wash cycle after having completed all of the installation steps in the pre- ceding paragraphs, turn on the water to the unit, partially open the door of the dishwasher, and press the on-off button "a" located on the control panel. The "b" indicator light will...
Page 8
Wash cycle table .7. Gb cycle cycle selection information description of cycle normal wash heavy duty light wash (iec-en50242) glassware rapid wash soak erf normal dirty dishes, pots and pans. Stan- dard daily cycle. Very dirty dishes, pots and pans. (not to be used with deli- cate items) normal dir...
Page 9
Energy saving tips -it is important to try and run the dishwasher when it is fully loaded in order to save on energy. In order to prevent odors from forming and food from caking onto the dishes, you can run the soak cycle. -choose the right wash cycle: the choice of cycle depends on the type of dish...
Page 10
Troubleshooting it may occur that the dishwasher does not function or does not function properly. Before calling for assistance, iet us see what can be done first: have you forgotten to press one of the buttons or to perform an essential operation? The dishwasher does not start have you checked whet...
Page 11
Installation .10. Gb positioning the appliance position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the ...
Page 12
Installation diagram the symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of c...