Summary of DW12-HFM ME
Page 1
Dw12-hfm dw12-hfm me dw12-hfm ss 0120503790 gb nl de fr it es pt.
Page 2
Safety is a good habit to get into close-up view (control panel) a b c on-off light on-off button handle for opening door d e f g "eco" button a f e low salt indicator light "1/2" button b c d g knob for selecting cycle - do not touch the heating element during or after a wash cycle. - do not lean o...
Page 3
Close-up view (interior) a b c d upper rack rack height adjustor top spray arm lower rack e f g h i washing filter bottom spray arm detergent and rinse aid dispenser salt container cap technical characteristics width 60 cm depth 60 cm height 85 cm capacity 12 standard place settings mains water pres...
Page 4
S a l t salt the hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Loading t...
Page 5
Detergent and rinse aid detergent detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "wash cycle table". The detergent dispenser is located on the inside panel of the doo...
Page 6
Loading the dishwasher .5. Gb lower rack upper rack load for 12 standard settings fig.A fig.B 2 1 3 4 fig.C before placing the dishes in the dishwasher, remove the large food particle to prevent the filter from becoming clogged, which results in reduced performance. If the pots and pans have baked-o...
Page 7
Starting the appliance starting a wash cycle... - make sure that the plug for the appliance is inserted into the wall socket. - make sure that the water supply is turned on to full pressure. - load the dishwasher (see the section entitled, "loading the dishwasher"). - pour in the detergent (see the ...
Page 8
Wash cycle table .7. Gb cycle eco button cycle selection information description of cycle deter- gent rinse aid i n t e n s i v e wash i n t e n s i v e wash normal wash rinse glassware soak very dirty dishes, pots and pans (not to be used with delicate items). Very dirty dishes, pots and pans. (not...
Page 9
- it is important to try and run the dishwasher when it is fully loaded in order to save on energy. In order to prevent odours from forming and food from caking onto the dishes, you can run the soak cycle. - choose the right wash cycle: the choice of cycle depends on the type of dishware, cookware a...
Page 10
Cleaning and special maintenance filter assembly for best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is a good idea to remove the larger food par...
Page 11
Installation positioning the appliance positioning the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left ...
Page 12
Diagram installation.