- DL manuals
- Haier
- Dishwasher
- DW12-TFE3 series
- Instructions For Use Manual
Haier DW12-TFE3 series Instructions For Use Manual
Summary of DW12-TFE3 series
Page 2
Dishwasher dw12-tfe3 series dw12-ufe3 series instructions for use en.
Page 3: Index
1 index safety information installation getting to know your dishwasher how to fill the salt how to fill rinse aid how to fill the detergent dispenser not suitable for the dishwasher arranging crockery, glasses, etc. In the dishwasher programme overview washing dishes how to keep your dishwasher in ...
Page 4: Safety Information
2 safety information at time of delivery check packaging and dishwasher immediately for signs of transport damage. If the appliance is damaged, do not put it into use but contact your supplier or customer service without delay. Please dispose of packaging materials properly. The dishwasher must only...
Page 5
3 if your family includes children the appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance. Keep detergents out of the reach of children, who must also be kept away from the ...
Page 6: Installation
4 positioning the appliance positioning the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilita...
Page 7
5 e lectrical connection a fter making sure that the voltage and frequency values for the current in the home correspond to those on the rating plate (located on the stainless steel inner door of the appliance) and that the electrical system is correct for the maximum voltage on the rating plate, in...
Page 8
6 electrical connection (uk only) for your safety please read the following information. Warning: this appliance must be earthed. The appliance must be connected to a 220-240 volts 50 cycle ac supply by means of a three pin socket, suitably earthed and should be protected by a 13 amp fuse in the plu...
Page 9
7 getting to know your dishwasher close-up view (control panel) dishwasher interior upper rack a b c d e f top spray arm silverware basket bottom spray arm lower rack detergent and rinse aid dispenser g h i j k salt container cap washing filter water inlet hose drain hose power supply cord a d e f h...
Page 10: How To Fill The Salt
8 salt the hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. How to fill the...
Page 11: Ow To Fill Rinse Aid
5 4 9 r inse aid t his product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door . L oading the rinse aid regardles s of the type of detergent dispenser installed on your appliance, you must proceed as indicated below when loading t...
Page 12
1 0 n ot suitable for the dishwasher what you should not put into the dishwasher c utlery and tableware manufactured in whole or part from wood.They become faded and unsightly in appearance.Furthermore,the adhesives that are used are not suitable for the temperature that occur inside the dishwasher....
Page 13
11 arranging crockery, glasses, etc. In the dishwasher before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from be- coming clogged, which results in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend...
Page 14
12 the upper rack is designed to hold more delicate and lighter dishware, such as glasses, cups and saucers, plates, small bowls and shallow pans (as long as they are not too dirty). How to use the upper rack fig.G fig.F shelf lean tall glasses and those with long stems against the shelf- not agains...
Page 15: Rogramme Overview
1 3 p rogramme overview wash programme type of crokery e.G. China, pots/ pans, cutlery, glasses, etc amount of food remains description of cycle condi- tion of food remains pre-wash with warm water. Extended wash at 70°c. Rinses with cold water. Rinse with hot water. Drying. Pre-wash use cold water....
Page 16
1 4 delayed start detergent rinse aid duration in minutes energy consump- tion in kwh water consump- tion in litres * en50242 test with rinse aid setting 5 112 112 102 102 162 162 92 92 32 54 12 1.62 1.24 1.24 1.24 1.05 1.05 1.12 1.12 0.40 0.50 0.02 18 16 15 13 15 12 12 10 9 5 3 ( ) prewash 5g 5g 5g...
Page 17: Washing Dishes
15 washing dishes programme selection the most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the details contained in the wash cycle table.The corresponding programme sequence, duration and consumpt...
Page 18
16 end of programme interrupping the programme open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open the door fully until spray arm has stopped rotating. When you open the door, the dishwasher will beep ten times every thirty seconds. If the appliance ...
Page 19
17 after 3 seconds the delayed start indicator “ e ” blinks, the time-remaining indicator “ g ” will blink and decrease , the programme will start until the delayed start indicator “ g ” goes out . 3 in1 function w hen using "3 in 1"combination products, the rinse-aid and salt lights are no longer u...
Page 20
18 how to keep your dishwasher in shape after every wash after every wash, turn off the water supply the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside. Remove the plug before cleaning or performing maintenance, always remove the plug from the socket. Do...
Page 21: Care And Maintenance
19 care and maintenance dishwasher salt check the low salt indicator “ g” .Top up with salt, if required. Regular inspection and maintenance of your appliance helps to prevent problems from occurring.This saves time and aggravation.You should therefore carefully inspect the inside of your dishwasher...
Page 22
20 inspect the nozzles in the spray arms for blocked holes due to remnants of food. If necessary, pull the lower arm “ 1 1 ” upwards and lift it off. Unscrew the upper spray arm “ 1 0 ”. Clean both spray arms under running water. Refit the spray arms. Ensure that the lower arm has locked into place ...
Page 23: Fault Finding
2 1 r esolving minor problems yourself e xperience has shown that you can resolve most problems that rise during normal daily usage yourself, without having to call out a service engineer.Not only does this save costs,but it also means that the appliance is available for use again that much sooner. ...
Page 24
22 when the buzzer emits 10 short warning signals every 30 seconds and the time-remain- ing indicator display "e4" have you checked whether: the drain hose is crimped or bent. The drain hose is too high. If you take all these checks and the dishwasher still does not function or your dish- washer hav...
Page 25
23 water remains inside appliance after programme has ended blockage or kind in drainage hose. Pump is jammed. Filters are blocked. The programme is still running. Wait for the programme to end . . ..During washing unusual amount of foam is creased n ormal washing up liquid has been poured into the ...
Page 26
24 not enough detergent was added to dispenser. Detergent has insuffcient bleaching properties. Use a detergent containing a chemical bleaching agent. P lastic items are discoloured n ot enough detergent was added to dispenser compartment. Amount of rinse-aid was set too low. Although water is quite...
Page 27: Echnical Data
2 5 t echnical data 12 standard place settings width depth height capacity mains water pressure power voltage total absorbed power 60 cm 60 cm 85 cm 0.03-0.6mpa 220-240v~ 50hz 1950w important information notes on waste disposal o ld appliances still have some residual value. An environment-friendly ...
Page 28
26 general information measures must be taken to ensure that built-under and built-in units that are subsequently re-sited as free-standing appliances cannot topple over. This can be achieved by bolting the dishwasher to the wall or fitting it under a continuous work surface which is screwed to the ...
Page 29
Disposal the symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, yo...