Haier ESA406K Use And Care Manual - page 14

14

■

Disturbances in your electrical current can trip (Reset 

button will pop out) the power supply cord.

 Press and 

release RESET (listen for click; Reset button will latch and on 

some devices, a green light will turn on) to resume operation.

■

Electrical overloading, overheating, cord pinching or 

aging can trip (Reset button will pop out) the power 

supply cord.

 After correcting the problem, press and release 

RESET (listen for click; Reset button will latch and on some 

devices, a green light will turn on) to resume operation.

NOTE:

 A damaged power supply cord must be replaced with a

new power supply cord obtained from the product manufacturer

and must not be repaired.

■

    The air conditioner is not properly sized for your room. Check 

the cooling capabilities of your room air conditioner. Room air 

conditioners are not designed to cool multiple rooms.

■

   The filter is dirty or obstructed by debris. Clean the filter.

■

    There is excessive heat or moisture (open container cooking, 

showers, etc.) in the room. Use a fan to exhaust heat or 

moisture from the room. Try not to use heatproducing 

appliances during the hottest part of the day.

■

    The louvers are blocked. Install the air conditioner in a  

location where the louvers are free from curtains, blinds, 

furniture, etc.

■

    The outside temperature is below 61°F (16°C). Do not try to 

operate your air conditioner in the cooling mode when the 

outside temperature is below 61°F (16°C).

■

    The temperature of the room you are trying to cool is  

extremely hot. Allow extra time for the air conditioner to cool 

off a very hot room.

■

    Windows or doors to the outside are open. Close all windows 

and doors.

■

    The Temperature control is not at a cool enough setting.  

Adjust the TEMP/TIME control to a cooler setting by  

pressing the minus button to reduce the temperature. Set the 

Fan Speed control to the highest setting.

■

  The current air conditioner replaced an older model.

The use of more efficient components may cause the air 

conditioner to run longer than an older model, but the total 

energy consumption will be less. Newer air conditioners do 

not emit the “blast” of cold air you may be accustomed to 

from older air conditioners, but this is not an indication of 

lesser cooling capacity or efficiency. Refer to the efficiency 

rating (EER) and capacity rating (in Btu/h) marked on the air 

conditioner.

■

  The air conditioner is in a heavily occupied room, or 

heatproducing appliances are in use in the room.

 Use 

exhaust vent fans while cooking or bathing and try not to use 

heatproducing appliances during the hottest part of the day. A 

higher capacity air conditioner may be required, depending on 

the size of the room being cooled.

■

    The air conditioner is not properly leveled. The air conditioner 

should slope slightly downward toward the outside. Level the 

air conditioner to provide a downward slope toward the  

outside to ensure proper drainage. See the Installation  

Instructions.

     NOTE:

 Do not drill a hole into the bottom of the metal base

     and condensate pan.

■

An extension cord is being used.

 Do not use an extension 

cord with this or any other appliance.

■

  You are trying to restart the air conditioner too soon after 

turning off the air conditioner.

 Wait at least 3 minutes after 

turning off the air conditioner before trying to restart the air 

conditioner.

Air conditioner power supply cord trips (Reset button

pops out)

Air conditioner cycles on and off too much or does not

cool room in cooling mode

Air conditioner seems to run too much

Water drips from cabinet into your house