Haier GDE700AW - Genesis 6 cu. Ft. Electric Dryer User Manual
Summary of GDE700AW - Genesis 6 cu. Ft. Electric Dryer
Page 1
Electric dryer sèche-linge genesis secadora eléctrica user manual model # hlf103q/r, gde700aw, chlf103q, cgde700aw guide de l’utilisateur modéle # hlf103q/r, gde700aw, chlf103q, cgde700aw manual del usuario para modelo de # hlf103q/r, gde700aw, chlf103q, cgde700aw quality • innovation • style.
Page 2
Important safety instructions warning - to reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow the basic precautions, including the following: 1. Read all of the instructions before using this appliance. 2. Don’t dry articles that have been previously clea...
Page 3: Save These Instructions
2 thank you for using our haier product. This easy-to-use manual will guide you in getting the best use of your dryer. Remember to record the model and serial number. They are on a label in back of the dryer. Model number serial number date of purchase staple your receipt to your manual. You will ne...
Page 4: Table of Contents
English 3 table of contents page safety instructions ....................................................................1 installation instructions ................................................4-12 tools and materials required ................................................................4 ele...
Page 5: Tools and Materials Required
English 4 • select a suitable location for the dryer on a hard even surface away from direct sunlight or heat sources, baseboard heaters, cooking appliances etc. Any floor unevenness should be corrected with leveling legs located on the bottom of the dryer. Tools and materials required • phillips he...
Page 6: Exhaust System Connections
English 5 exhaust system connections 1. Do not use plastic flexible duct to exhaust the dryer. Excessive lint can build up inside exhaust system and create a fire hazard and restrict air flow. Restricted air flow will increase dryer times. If your present system is made up of plastic duct or metal f...
Page 7
English 6 materials use only 4 inch (10.2cm) diameter (minimum) rigid of flexible metal duct and approved vent hood which has a swing-out damper hat open when the dryer is in operation. When the dryer stops, the dampers automatically close to prevent drafts and the entrance of insects and rodents. T...
Page 8: Location of Your Dryer
English 7 location of your dryer do not install your dryer: • in an area exposed to dripping water or outside weather conditions. • in an area where it will come in contact with curtains, thick carpet,or any thing that will obstruct the flow of combustion and ventilation air. • on carpet floor must ...
Page 9
English 8.
Page 10: Electrical Connections
English 9 electrical connections requirements and instructions the following are specific requirements for proper and safe electrical installation of your dryer. Failure to follow these instructions can create electrical shock and/or fire hazard. Warning 1. This appliance must be properly grounded. ...
Page 11
English 10 3-wire cord connections (usa only) 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. 2. Install a u.L. Approved strain relief into the power cord entry hole of the mounting bracket. Finger ti...
Page 12
English 11 4-wire cord connections 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. 2. Install a ul approved strain relief into the power cord entry hole of the mounting bracket . Finger tighten the nu...
Page 13
English 12 4. Thread a u.L. Approved 30 amp power cord. Nema 14-30 type st or srdt through the strain relief. 5. Attach the green power cord ground wire to the cabinet with green ground screw. 6. Attach the white (neutral) power cord conductors to the outer cord and the green ground wire from the dr...
Page 14: Operating Instructions
English 13 operating instructions understanding the control panel note: features may vary per model. Start/pause button: (1) • press the button to turn the dryer on. Press this button once to start the dry process. Press this button once again to pause the activity during the dry cycle. Off button: ...
Page 15
English 14 more time & less time button: (7) • set time from 0 to 180 minutes when timed dry or rack dry cycle selected. Timed-dry cycles button: (8) • "timed-dry cycles" button will let you select your desired dry mode. Timed dry: you can set status of "temp", "signal" and dry time with "more time"...
Page 16: Preparations Before Drying
English 15 preparations before drying • sort the clothes of the same kind (cotton, synthetics, woolen) to dry. • dark and light colored clothes should be separately dried. Fabrics prone to losing lint and those prone to adhering lint shall be separately dried. Clothes prone to falling lint should be...
Page 17: Load Clothes Into Dryer
English 16 • the appropriate load shall be 1/3 ~ 1/2 of the drum volume. Avoid too much load, space is needed to allow clothes free rotation for uniform and wrinkle proof drying. • when drying big articles, only 2-3 pieces shall be loaded at a time and supplemented with small and medium sized articl...
Page 18
English 17 2. Press "auto-dry cycles" button to select a suitable full automatic cycle. • the normal program will be automatically selected after powering on. If another full automatic program is desired, press "auto-dry cycles" button until corresponding indicator turns on. • to select your desired...
Page 19
18 français 4. Press "temp" button to set a suitable drying temperature. • after switching on, the dryer sets corresponding temperature adapting to different program selected. If other drying temperature is wanted, press "temp" button to enable such a selection. 5. Press "signal" button, a buzzer wi...
Page 20: Timed Dry Cycle
19 français timed dry cycle 1. Press any button except "off" button to power on. 2. Press "timed-dry cycles" button and select "timed dry" cycle. • after powering on, press "timed-dry cycle" button to select "timed dry" program. 3. Press "more time" and "less time" buttons to set a suitable time. • ...
Page 21: Rack Dry Cycle
20 français rack dry cycle 1. Press any button except "off" button to power on. 2. Press "timed-dry cycles" button and select "rack dry" cycle. • after powering on, press "timed-dry cycle" button to select "rack dry" program. 3. Press "more time" and "less time" buttons to set a suitable time. • aft...
Page 22: Normal Operating Sounds
21 the following sounds are normal during the operation of the dryer. • tumbling sound: this is normal as the heavy wet clothes in the dryer are continuously being tossed around. • air rushing noise: this happens as the dryer drum spins at very high rpm and the air is rushing through the dryer drum....
Page 23: Trouble Shooting
22 trouble shooting dryer does not operate: • check if unit is plugged in. The plug may have come loose. • check if the electrical wall receptacle is of proper voltage. • check if the circuit breaker needs to be reset or if the fuse needs to be replaced. • check if the unit is in the “off” model. Pr...
Page 24: Limited Warranty
Limited warranty full one year warranty for 12 months from the date of original retail purchase, haier will repair or replace any part free of charge including labor that fails due to a defect in materials or workmanship. Limited warranty after only year from the original retail pur- chase date haie...
Page 25: Important
Made in china fabriqué en chine hecho en china haier america new york, ny 10018 printed in china hlf103q issued: july 2006 important do not return this product to the store if you have a problem with this product, please contact the "haier customer satisfaction center" at 1-877-337-3639. Dated proof...