- DL manuals
- Haier
- Dryer
- GDZ22-1
- User Manual
Haier GDZ22-1 User Manual
Summary of GDZ22-1
Page 1
Electric dryer user manual- guide de l’utilisateur- manual del usuario- model # modèle para modelo de gdz22-1 sèche-linge Électrique secador-eléctrico gdz22-1 manual 10/22/01 11:45 am page 1.
Page 2
Important safety instructions warning – to reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow basic precautions, including the following: 1. Read all instructions before using the appliance. 2. Do not dry articles that have been previously cleaned in, was...
Page 3: Save These Instructions
2 16. This dryer must be properly installed in accordance with the installation instructions before it is used. See grounding instructions in the installation section. 17. Proper grounding must be ensured to reduce the risk of electric shock and fire. Check with a qualified electrician or service pe...
Page 4: Warning
3 english as dry cleaning solvents, gasoline, vegetable and cooking oils are highly hazardous materials, items soaked in or spotted with such should not be used in the dryer. Items may still contain a substantial amount of the hazardous material after being washed. When such items are exposed to hea...
Page 5: Table of Contents
Table of contents page safety instructions ............................................................................1 operating instructions ............................................................5 features ........................................................................................
Page 6: Operating Instructions
5 english features control knob: 1. Dry timer: lets you set the time to dry your clothes, depending on the fabric type and depending on the load size. This is designed for you to set the number of minutes needed to dry the clothes. This cycle provides up to 100 minutes of drying time at the temperat...
Page 7
6 english temperature knob: temperature setting control: to set the heat drying temperature, of the dryer load, depending on the fabric type. • low heat: for knitted and delicate clothes. • med. Heat: for permanent press, synthetic clothes. • high heat: for regular clothes. Always follow directions ...
Page 8
7 english your dryer also has the following features for your convenience: dry sensor: (feature only active in auto dry cycle) • this senses the dampness in the clothes. The dryer will automatically shut itself off once it senses that the clothes are dry. End of cycle signal: • your dryer is equippe...
Page 9
8 english operations 1. Sort clothes for drying. Separate dark and light colored items, like you do for washing. Check for stains that may not have been removed in washing. Dryer heat may permanently set some stains. Properly dried clothes will need minimum of care when removed from dryer. 2. Load u...
Page 10
9 english normal operating sounds following sounds are normally heard during the operation of the dryer. • tumbling sounds: this is normal as the heavy wet clothes in the dryer are continuously being tossed around. • air rushing noise: this happens as the dryer drum spins at very high rpm and the ai...
Page 11: Care and Cleaning Guide
10 english care and cleaning guide • lint filter needs to be cleaned before and after each use for your unit to operate at optimum efficiency. The filter can be slid out, by pulling on the tab located on the inside of the dryer door. The filter may be washed or vacuumed. Remove the excess water from...
Page 12: Troubleshooting
11 english dryer does not operate: • check if unit is plugged in. The plug may have come loose. • check if the electrical wall receptacle is of proper voltage. • check if the circuit breaker needs to be reset or if the fuse needs to be replaced. • check if the unit is in “off” mode. Press start butt...
Page 13: Installation Instructions
12 english select a suitable location for the dryer on a hard even surface away from direct sunlight or heat source e.G. Radiators, baseboard heaters, cooking appliances etc. Any floor unevenness should be corrected with the leveling legs located on the bottom of the dryer. • phillips head and flath...
Page 14: Warning
English the following are specific requirements for proper and safe operation of your dryer. Failure to follow these instructions can create excessive drying times and fire hazards. Warning 1. Do not use plastic flexible duct to exhaust the dryer. Excessive lint can build up inside exhaust system an...
Page 15
14 english materials use only 4 inch (10.2 cm) diameter (minimum) rigid or flexible metal duct and approved vent hood which has a swing-out damper hat open when the dryer is in operation. When the dryer stops, the dampers automatically close to prevent drafts and the entrance of insects and rodents....
Page 16
15 english after installation is completed, the following method must be used to determine if the exhaust system is acceptable: 1. Connect an inclined or digital manometer between the dryer and the point the exhaust connects to the dryer. 2. Set the dryer timer and temperature to air fluff (cool dow...
Page 17
16 english do not install your dryer: • in an area exposed to dripping water or outside weather conditions. • in an area where it will come in contact with curtains, drapes, or anything that will obstruct the flow of combustion and ventilation air. • on carpet. Floor must be solid with a maximum slo...
Page 18
17 english • dryer must be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. Metal ducting must be 4 inches (10.16 cm) in diameter with no obstructions. Rigid metal duct is preferred. • if dryer is exhausted through the floor and area ben...
Page 19: Warnings
18 english 1. This appliance must be properly grounded. Electrical shock can result if the dryer is not properly grounded. Follow the instructions in this manual for proper grounding. 2. Do not use an extension cord with this dryer. Some extension cords are not designed to withstand the amounts of e...
Page 20
English 19 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. 2. Install a u.L. Approved strain relief into the power cord entry hole of the mounting bracket. Finger tighten the nut only at this time. 3....
Page 21
20 english 4-wire cord connections 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. 2. Install a u.L. Approved strain relief into the power cord entry hole of the mounting bracket. Finger tighten the n...
Page 22
English 21 4. Thread a u.L. Approved 30 amp power cord, nema 14-30 type st or srdt through the strain relief. 5. Attach the green power cord ground wire to the cabinet with green ground screw. 6. Attach the white (neutral) power cord conductor from the power cord and the green ground wire from the d...
Page 23: Limited Warranty
22 english limited warranty full one year in-home warranty for 12 months from the date of original retail purchase, haier will repair or replace any part free of charge including labor that fails due to a defect in materials or workmanship. Limited warranty after one year from the original retail pu...
Page 24: Important
Gdz22-1-02 issued: june-01 important do not return this product to the store if you have a problem with this product, please contact the "haier customer satisfaction center" at 1-877-337-3639. Dated proof of purchase required for warranty service important ne pas réexpédier ce produit au magasin pou...