1 haier front loading dryer service manual part # wd-8888-22 haier america trading, llc www.Haieramerica.Com.
2 table of contents features 3 specifications 4 safety caution 5 unpacking and installation 7 troubleshooting 8 dimensions 11 names of parts 11 circuit wiring 12.
3 features ● three drying cycle, heat cool and synthetic. ● the support of front and rear make running balanced low noise. ● straight exhaust of back-inhale styled make good airproof and high drying efficiency. ● after heat drying cool may protect clothes..
4 specifications models gdz5-1 capacities capacities 11lb drum size 117l 2800rpm 220-240v/50hz motor size (hp) 250w/150w features type direct exhaust controls mechanism temperature settings 3 kinds dry sensor no reversible door no end of cycle signal no wrinkle remover tumble no easy access lint fil...
5 safety precautions warning! To reduce the risk of fire, electrical shock, or injury to persons when using this dryer, comply with the basic warnings listed below. Warning! Failure to comply with these warning could result in serious personal injuries or damage to the dryer. Warning! Do not dry ite...
6 warning! Destroy the carton, plastic bag and other packing materials after the dryer is unpacked. Children might use them for play. Cartons covered with rugs, bedspreads or plastic sheets can become airtight chambers. Warning! Keep laundry products out of children’s reach. To prevent personal inju...
7 unpacking and installation 1. Open the package, check against the instruction manual to see if the spare parts are complete. 2. Put the dryer to the location required by the user (balcony, kitchen, toilet or living room). According to the condition of the installation position, give the user advic...
8 troubleshooting a. The power light is on, but the machine does not work after a program is set. A. Check the micro switch. If it is out of order, replace it; otherwise, check to see if it is closed or it is open, check the switch arm height and adjust it. Maintenance procedure: 1) loosen the screw...
9 1) the overheat temperature controller of the heating component is turned off. Maintenance procedure remove the back guard plate, check to see if the high-temperature thermostat is in order. Check procedure: take down the cable plug and measure the high-temperature thermostat with an avo meter to ...
10 maintenance procedure 1) open the deck plate, pull out the power line terminal, then open the back cover and remove the belt, pull out the power line terminal of the heater and remove the back cover. 2) unscrew the drum holder on the front channel with a screwdriver and replace it. 3) reinstall t...
11 dimensions names of parts.
12 circuit wiring (new zealand, australia, cyprus) circuit wiring (america and canada).
