Haier HDW12-TFE3SS Instructions For Use Manual - Index

Summary of HDW12-TFE3SS

  • Page 1

    0120504778d dishwasher hdw12-tfe3ss hdw12-tfe3wh instructions for use.

  • Page 2: Index

    En index safety information installation getting to know your dishwasher how to fill rinse aid how to fill the detergent dispenser not suitable for the dishwasher arranging crockery, glasses, etc. In the dishwasher programme overview washing dishes how to keep your dishwasher in shape care and maint...

  • Page 3: Safety Information

    En safety information 2 at time of delivery check packaging and dishwasher immediately for signs of transport damage. If the appliance is damaged, do not put it into use but contact your supplier or customer service without delay. Please dispose of packaging materials properly. The door should not b...

  • Page 4

    En if your family includes children this appliance is not intended for use by persons (including children) with reduced physical,sensory or mental capcabilities, or lack of experience and knowledge,unless they have been given supervi- sion or instruction concerning use of the appliance by a person r...

  • Page 5: Installation

    Before you start safety and compliance these instructions are intended as a guide only. It is the responsibility of the installer to ensure that installation complies with applicable regulations and local government by-laws. Installation must be performed by a suitably qualified person. Incorrect ins...

  • Page 6

    Product and cabinetry dimensions $ % ( ) * & ' * the top panel may be removed to suit underbench cavity height. See instructions further below. **depending on feet height adjustment. Product dimensions (mm) a overall height of product with top panel in place with top panel removed* 850 (min) -870 (m...

  • Page 7

    1 preparing the product and cabinetry the top panel may be removed to suit underbench cavity height. See the illustrations below. Important! To prevent possible steam damage to the cabinetry, ensure that any bare wood surrounding the dishwasher is sealed with an oil-based paint or moisture-proof pol...

  • Page 8

    1 2 4 3 levelling and positioning the dishwasher before sliding the dishwasher into position, adjust the feet with a spanner (1) to ensure that the dishwasher is level (2) and the required height. Do not lift the dishwasher from the door handle or top panel. Position the dishwasher in the cavity, en...

  • Page 9

    Plumbing -- waste connection these drainage options are designed to eliminate problems that occur with combined sink-dishwasher waste systems. Drainage option a: separate sink and dishwasher waste systems the standpipe must have a minimum diameter of 38 mm and stand 750 mm above the floor. Use the s...

  • Page 10

    Plumbing -- water inlet connection important! The appliance should be connected to the water main using the new water inlet hose supplied. Old hoses should not be used. Do not shorten the inlet hose. 1 take note of water connection requirements. The dishwasher has a single valve water connection. We...

  • Page 11

    Electrical connection the dishwasher must not be connected to the electrical supply while installation is being carried out. Ensure all domestic wiring is properly earthed. Check the rating label and ensure that the voltage and frequency values for the current in the house correspond to those on the...

  • Page 12

    En 11 h i j low rinse aid indicator light heat indicator light knob for selecting cycle a b c d "power" light "power" button "half load" light "half load" button e "delay" light f "delay" button g time-remaining indicator j a d c g f h i e b delay detergent and rinse aid dispenser e f g bottom spray...

  • Page 13: How to Fill Rinse Aid

    En 12 how to fill rinse aid important proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spot- ting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjustor to a lower setting. Rinse aid this p...

  • Page 14

    En 4 3 how to fill the detergent dispenser detergent detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle fol- lowing the instructions provided in the "programme overview". The de- tergent dispenser is located on th...

  • Page 15

    En not suitable for the dishwasher what you should not put into the dishwasher cutlery and tableware manufactured in whole or part from wood.They become faded and unsightly in appearance.Furthermore,the adhesives that are used are not suitable for the temperature that occur inside the dishwasher.Del...

  • Page 16

    En arranging crockery, glasses, etc. In the dishwasher before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, which re- sults in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend...

  • Page 17

    En the upper rack is designed to hold more delicate and lighter dishware, such as glasses, cups and saucers, plates, small bowls and shallow pans (as long as they are not too dirty)(see fig.E). How to use the upper rack fig.G fig.F shelf lean tall glasses and those with long stems against the shelf-...

  • Page 18: Programme Overvie

    En programme overvie w w ash programme description of cycle pre-wash with hot water. Extended wash. Rinses with cold water. Rinse with hot water. Drying. Prewash use cold water. Extended wash. Rinse with cold water. Rinse with hot water. Drying. Hot rinse. Drying. Short wash. Cold rinse. Short cold ...

  • Page 19: Washing Dishes

    En programme selection the most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the details contained in the wash cycle table.The corresponding programme sequence, duration and consumption details are...

  • Page 20

    En end of programme interrupting the programme open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open the door fully until spray arm has stopped rotating. When you open the door, the dishwasher will beep ten times every thirty seconds. If the appliance ...

  • Page 21

    En after 3 seconds the delayed start indicator “ e ” blinks, the time-remaining indicator “ g ” will blink and decrease , the programme will start until the delayed start indicator “ g ” goes out . Reset drain function you can use reset drain function to stop the washing cycle under running by rotat...

  • Page 22

    En how to keep your dishwasher in shape after every wash after every wash, turn off the water supply the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside. Remove the plug before cleaning or performing maintenance, always switch off the remove the plug from...

  • Page 23: Care and Maintenance

    En care and maintenance regular inspection and maintenance of your appliance helps to prevent problems from occurring.This saves time and aggravation.You should therefore carefully inspect the inside of your dishwasher from time to time. Overall condition of appliance check that no grease or scale h...

  • Page 24: Trouble Shooting

    En inspect the nozzles in the spray arms for blocked holes due to remnants of food. If necessary, pull the lower arm “ 10 ” upwards and lift it off. Unscrew the upper spray arm “ 9 ”. Clean both spray arms under running water. Refit the spray arms. Ensure that the lower arm has locked into place and...

  • Page 25

    En when the buzzer emits 10 short warning signal every 30 seconds and the time-remaining indicator display "e3" have you checked whether: the drain hose is too low. Error display on the time-remaining indicator 24 when the buzzer emits 10 short warning signals every 30 seconds and the time-remain- i...

  • Page 26

    En if you take all these checks and the dishwasher still does not function or your dish- washer have any other error display, you can power the dishwasher off, and wait a few minutes. You can power the dishwasher on, try it again , if the dishwasher still does not function and/or the problem persist...

  • Page 27

    En water remains inside appliance after programme has ended blockage or kind in drainage hose. Pump is jammed. Filters are blocked. The programme is still running. Wait for the programme to end . ...During washing unusual amount of foam is creased normal washing up liquid has been poured into the ri...

  • Page 28

    En not enough detergent was added to dispenser. Detergent has insuffcient bleaching properties. Use a detergent containing a chemical bleaching agent. Plastic items are discoloured not enough detergent was added to dispenser compartment. Amount of rinse-aid was set too low. Although water is quite h...

  • Page 29: Technical Data

    En technical data 12 standard place settings width depth height capacity mains water pressure power voltage total absorbed power 60 cm 60 cm 85 cm 0.03-1.0mpa 1950w maximum current intensity important information notes on waste disposal old appliances still have some residual value. An environment-f...

  • Page 30

    En general information measures must be taken to ensure that built-under and built-in units that are subsequently re-sited as free-standing appliances cannot topple over. This can be achieved by bolting the dishwasher to the wall or fitting it under a continuous work surface which is screwed to the ...