- DL manuals
- Haier
- Dishwasher
- HDW9TFE3SS HA AA
- Instructions For Use Manual
Haier HDW9TFE3SS HA AA Instructions For Use Manual
Summary of HDW9TFE3SS HA AA
Page 1
Dishwasher tfe3 series instructions for use hdw9-tfe3wh hdw9-tfe3ss 0120505889a en power 3 in 1 delay heavy normal light glassware pre-rinse rinse quick 30 1 2 3 4 5 6 7.
Page 2: Index
1 index en disposal the symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of c...
Page 3: Safety Information
2 safety information at time of delivery check packaging and dishwasher immediately for signs of transport damage. If the appliance is damaged, do not use it and contact the retailer or our approved customer service department without delay. Please dispose of packaging materials properly. En the dis...
Page 4: If A Fault Occurs
3 if your family includes children or the infirm the appliance is not intended for use by young children or infirm persons without supervision. Keep detergents out of the reach of children. If a fault occurs if the appliance malfunctions, turn off the water supply to the appliance, switch it off and...
Page 5: Before You Start
Before you start safety and compliance these instructions are intended as a guide only. It is the responsibility of the installer to ensure that installation complies with applicable regulations and local government by-laws. Installation must be performed by a suitably qualified person. Incorrect in...
Page 6
Product and cabinetry dimensions a b e f g c d * the top panel may be removed to suit underbench cavity height. See instructions further below. **depending on feet height adjustment. Product dimensions (mm) a overall height of product with top panel in place with top panel removed* 850 (min) -870 (m...
Page 7
1 preparing the product and cabinetry the top panel may be removed to suit underbench cavity height. See the illustrations below. Important! To prevent possible steam damage to the cabinetry, ensure that any bare wood surrounding the dishwasher is sealed with an oil-based paint or moisture-proof pol...
Page 8
1 2 4 3 levelling and positioning the dishwasher before sliding the dishwasher into position, adjust the feet with a spanner (1) to ensure that the dishwasher is level (2) and the required height. Do not lift the dishwasher from the door handle or top panel. Position the dishwasher in the cavity, en...
Page 9
Plumbing -- waste connection these drainage options are designed to eliminate problems that occur with combined sink-dishwasher waste systems. Drainage option a: separate sink and dishwasher waste systems the standpipe must have a minimum diameter of 38 mm and stand 750 mm above the floor. Use the s...
Page 10
Plumbing -- water inlet connection important! The appliance should be connected to the water main using the new water inlet hose supplied. Old hoses should not be used. Do not shorten the inlet hose. 1 take note of water connection requirements. The dishwasher has a single valve water connection. We...
Page 11
Electrical connection the dishwasher must not be connected to the electrical supply while installation is being carried out. Ensure all domestic wiring is properly earthed. Check the rating label and ensure that the voltage and frequency values for the current in the house correspond to those on the...
Page 12: Dishwasher Interior
11 getting to know your appliance close-up view (control panel) dishwasher interior upper rack a b c d e f g h i j top spray arm silverware basket bottom spray arm lower rack detergent and rinse aid dispenser washing filter water inlet hose drain hose power supply cord "3 in 1" indicator heater indi...
Page 13: Rinse Aid
Rinse aid this product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door. When the low rinse aid indicator lights up on the control panel (see fig.A), you must add rinse aid. Adding rinse aid regardless of the type of detergent disp...
Page 14: Detergent
5 4 13 how to fill the detergent dispenser detergent detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "programme overview". The detergent dispenser is located on the in...
Page 15: Non-Dishwasher Items
14 non-dishwasher items cutlery and tableware manufactured in whole or part from wood. These will become faded and deteriorate quickly. Furthermore, the adhesives that are used are not suitable for the temperature inside the dishwasher. Delicate decorative glassware and vases, special antique or irr...
Page 16: Loading The Dishwasher
15 loading the dishwasher before placing the dishes in the dishwasher, remove the larger food scraps to prevent the filter from becoming clogged.If the pots and pans have baked-on food that is extremely hard to remove,we recommend they are soaked before washing. This will eliminate the need for extr...
Page 17: Programme Overview
16 programme overview en when the programme is finished leave the door open30°(approximately 100mm) to improve the drying performance. “ ” be able to applied “ ”not to be applied w ash programme description of cycle pre-wash with hot water. Extended wash at 68°c. Rinses with cold water. Rinse with h...
Page 18: Washing Dishes
17 washing dishes programme selection the most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., and the amount and condition of food residue, with the details contained in the programme overview. The corresponding programme sequence, duration and consumption ...
Page 19: End of Programme
Switch dishwasher on. Immediately press the delayed start button "f". The delayed start indicator "e" blinks and the time remaining indicator "g" changes to " ". Press the delayed start button for 2 seconds until the numerical display shows the required delay. To cancel the time delay setting, press...
Page 20: 3 In 1 Function
19 after 3 seconds the delayed start indicator "e" blinks. The time-remaining indicator "g" will also blink. The programme will start when both lights fade. 3 in 1 function when using "3 in 1" combination products, the rinse-aid lights are no longer relevant. It may be helpful to select the lowest p...
Page 21: Care & Maintenance
20 care & maintenance after every wash after every wash leave the door slightly ajar so that moisture and odours are not trapped inside. Remove the plug before cleaning or performing maintenance, always switch off the machine and remove the plug from the socket. No solvents or abrasive cleaning prod...
Page 22: Care and Maintenance
21 care and maintenance regular inspection and maintenance of your appliance helps to prevent problems from occurring. This saves time and aggravation. You should therefore carefully inspect the inside of your dishwasher from time to time. Overall condition of appliance check that no grease or scale...
Page 23: Spray Arms
22 inspect the nozzles in the spray arms for holes blocked due to food residue. If necessary, pull the lower arm "11" upwards and lift it off. Unscrew the upper spray arm "10". Clean both spray arms under running water. Refit the spray arms. Ensure that the lower arm has locked into place and the up...
Page 24: Trouble Shooting
23 resolving minor problems yourself experience has shown that you can resolve most problems that arise during normal daily usage yourself without having to call out a service engineer. Not only does this save costs, but it also means that the appliance is available for use again that much sooner. T...
Page 25
24 when the buzzer emits 10 short warning signals every 30 seconds and the time-remaining indicator displays"e4" have you checked whether: the drain hose is creased or kinked. The drain hose is too high. If you carry out all these checks and the appliance still does not function or your appliance ha...
Page 26: ...During Washing
25 water remains inside appliance after programme has ended. Blockage or kink in drainage hose. Pump is jammed. Filters are blocked. The programme is still running. Wait for the programme to end. ...During washing unusual amount of foam is created normal washing up liquid has been poured into the ri...
Page 27
26 not enough detergent was added to dispenser. Detergent has insufficient bleaching properties. Use a detergent containing a chemical bleaching agent. Plastic items are discoloured not enough detergent was added to dispenser compartment. Amount of rinse-aid was set too low. Water softener was set t...
Page 28: Technical Data
27 technical data 9 standard place settings width depth height capacity mains water pressure power voltage total absorbed power 450 mm 600 mm 850 mm 0.03-1.0mpa 220-240v~ 50hz 1950w maximum current intensity 10a important information notes on waste disposal old appliances still have some residual va...