Haier HDY-D70-E Service Manual - Condenser Tumber Dryer
11
Condenser Tumber Dryer
HDY-D70-E
D+E composite button and child lock function
During a program, press and hold down both buttons for 3 seconds to
set up the child lock function if necessary. At this time, The display screen
shows the remaining time and the lock alternatively, and the control panel will
lock. Press and hold down both buttons for 3 seconds once again and the child
lock will release.When the program is end or the power off during the program,
the child lock will release.
H - LED screen
The screen displays the remaining time for a program, the delay time and
other related information.
Note: The remaining time to start a program is the default time for the
program. During operation, with variation of factors such as the moisture
content. The actual remaining time will be automatically adjusted until the preset
drying result has been achieved and the program is complete.
G - Programme progress display
Depending on the programme selected, the drying stage reached is
shown by the indicator lamps on the control panel:
- Drying
- Ready to iron
- Airing
- End/Anti-crease
At the end of a programme,the End/Anti-crease indicator lamp comes on.
The drum will continue to rotate at intervals to prevent laundry creasing, if you
do not wish to remove it immediately.
I - Maintenance displays
- Empty tank
- Clean filter
- Clean condenser
Important: After each drying cycle,
– Clean the filter;
– Drain the condensed water container;
(See section “Cleaning and maintenance”)
J -
Séchage
Prêt à repasser
Air frais
Anti-froissage
Bac plein
Filtre
Condenseur