Haier HPE20SS - 20 Cup Espresso/Cappucino Maker User Manual - Operation

English

6

OPERATION

Filling the Water Tank

Warning! Never operate the appliance without water in the tank.

Always remember to fill the tank when the water level is low

but be careful not to exceed the MAX level mark. 

To remove the water tank, simply pull out the tank and fill it with water.

Do not exceed the MAX level indicated on the water tank.  To fill the

tank without fully removing it, pull it out halfway and pour water directly

into it from a jug. Replace the tank, making sure the arrow and dots on

the tank are aligned with the arrow and dots on the housing, then push

into place.

Preheating the Espresso Machine

To ensure that your espresso coffee is dispensed at the correct

temperature, it is essential that the espresso machine be preheated.

• Turn on the upper switch by pressing down on the right side of the

button.  The red light next to the “      “ symbol will turn on. 

• Attach the empty filter holder to the machine by positioning it under

the boiler outlet with the arrow on the handle pointing towards the

left arrow (open) on the housing. Push upwards and at the same time

turn the handle to the right so that it points to the triangle marking at

the center of the housing (close).  

• Position a cup under the filter holder. Use the same cup that the

coffee will be served in, so that it may be preheated.

• Turn on the lower switch for about 20 seconds, then turn off so as to

partially fill the boiler. Some water may drip out from the dispensing

holes on the filter holder.

• Wait until the green ”OK” light comes on, then turn on the lower

switch. Allow water to flow until the green “OK” light turns off, then

stop the flow of water by turning off the lower switch.

• Empty the cup, wait until the green “OK” light turns on again and

repeat the process.