Haier HSU-09HVd03 Operation Manual - page 6
Maintenance
6
Setting of proper room
temperature
Close doors and windows
during operation
If the unit is not to be used
for a long time, turn off the
power supply main switch.
Use the timer effectively
Use the louvers effectively
Do not block the air inlet
or outlet
Proper
temperature
During cooling operation
prevent the penetration
of direct sunlight with
curtain or blind
OFF
Remote Controller
Indoor Body
For Smart Use of The Air Conditioner
Replacement of Air Purifying Filter
Do not use water,wipe the controller
with a dry cloth.Do not use glass
cleaner or chemical cloth.
wipe the air conditioner by using a
soft and dry cloth.For serious stains,
use a neutral detergent diluted with
water.Wring the water out of the
cloth before wiping,then wipe off the
detergent completely.
Air Filter cleaning
Open the inlet grille by pulling it upward.
Remove the filter.
Clean the filter.
Attach the filter.
Close the inlet grille.
Push up the filter's center tab slightly until it is
from the stopper, and remove the filter downward.
Use a vacuum cleaner to remove dust, or wash the filter with
water.After washing, dry the filter completely in the shade.
Attach the filter correctly so that the "FRONT" indication
facing to the front.Make sure that the filter is
fixed behind the stopper.If the right
attached correctly, that
Do not use the following for cleaning
Gasoline,benzine, thinner or cleanser
ay damage the coating of the unit.
Hot water over 40
O
C(104
O
F) may
discoloring or deformation.
Once every
two weeks
m
cause
released
is
completely
and left filters are not
may cause defects.
1.Open the lnlet Grille
2.Detach the standard air filter
3.Attach Air Purifying Filter
4.Attach the standard air filter
(Necessary installation)
5.Close the Inlet Grille
Close the Grille surely
Slide the knob slightly upward to
release the filter, then withdraw it.
Detach old Air Purifying Filter
Prop up the inlet grille by using a
small device named grille-support
which located in the right side of
the indoor unit.
The green aspect of the bacteria-killing medium air purifying filter will
face outside, the white aspect will face to the machine.
Note: the bacteria-killing mediums placed on the left side.
The multi-lights touching intermediary is placed on the right side.
Common sense:
1.For the units with UV light degerming function, the air purifying filter
of the bacteria-killing medium and the multi-lights touching intermediary
is effective for a long time and don’t need to be changed(UV light
the nano TiO
2
on the multi-lights touching intermediary, and the
2.For the units without UV light degerming function, the air purifying
degerming effect is highly
efficient and lasting.Multi-lights touching
filter of the multi-lights touching intermediary will be solarized in fixed
time. In normal family, it will be solarized every 6 months. The
3.But in the use, please note to clean the filter frequently( take off the
lowered due to the dust covering the filter. Multi-lights touching
intermediary and bacteria-killing medium filter is strictly prohibited from
The bacteria-killing medium filter not in use should be stored in shade,
cool and dry place.Please don’t expose it to the sunlight for a long time
Put air purifying filter appliances into the
right and left filter frames.
emitted by the UV light device of the indoor unit catalytically activates
intermediary don’t need to be exposed to be sunlight).
solarization time will last no less than 8 hours under the state of
abundant sun.
back suction cleaner or lightly pat it) to avoid the operating effect is
being cleaned by water.
otherwise the degerming performance will drop.