Haier LED19 Instruction Manual - Usb Mode

Using the features

EN-27    Digital LCD Television Instruction Manual 

Time

V

While in normal TV mode only, pressing the button 

 will display the teletext time in the top right hand 

corner for a few seconds.

Fast text coloured

V

buttons

Fast text automatically displays the four most 

commonly used pages that the broadcaster thinks 

that you may want to choose next. Press the same

coloured button on the remote control as the 

coloured link at the bottom of the teletext page to go 

directly to that page.

Subcode

V

Pressing the 

 button by entering its 4-digit number 

to enter a secondary page.

USB MODE

 Note 

The diagrams in the following section are 

O

schematic and only for your reference. Please see 

the actual product if necessary.

TO USE THE USB DEVICE

Supported file formats:

A

Photo: *.jpg;

t

Music: *.mp3 files;

t

Movie: *.avi files;

t

TEXT: *.txt

t

 Note

Due to the particularity of file cording, some files 

O

may be unable to read.

Supported equipment: 

B

Support the equipment that supports Mass Storage 

Protocol and whose file system is FAT32, such 

as some USB disks, mobile harddisks, and MP3 

player. If USB equipment could not be identified 

due to unsupported file system, please format the 

equipment to the above-mentioned file system.

To achieve smooth playing, ensure the following:

C

The file code rate should be lower than 300KB/S;

t

Due to the limitation of USB signal transmission 

t

distance, it is recommended not to use USB patch 

cord, in case of using the cord, make sure that its 

length is not over 1m;

Use high-speed USB equipment in conformity 

t

with USB2.0 full speed Interface Standard; If USB 

equipment in conformity with USB1.1 full speed 

Interface Standard is used, the playing may be 

unsmooth.

When connecting/removing the USB 

device

Press “

A

SOURCE” on the remote control unit to select 

USB option.

Insert USB equipment into corresponding USB 

B

interface 2s after starting the system.

After entering the system menu, press “

C

/“ on the 

remote control unit to select the require USB files, 

press “OK” button to confirm the selection and enter 

the file list relative to the selection.

Press 

D

“/“ on the remote control unit to select the 

required file, press “OK” button to enter the selected file.

To exit the streaming media playing system and 

E

watch a TV program, you must press “BACK” button 

to return to the streaming media main menu at first 

(to protect equipment), and then press “SOURCE” to 

select “TV” to return to the TV mode.

 Note

Under source of USB, when

Q

press button MENU,

screen goes black, except when images or movies 

are being played.

While playing the USB, press “

Q

BACK” button 

repeatly, the screen picture will return to USB 

main interface, and only at this time you can 

switch corresponding signal sources by pressing 

“SOURCE” again.