Instruction and installation manual 60cm fully integrated dishwasher model: udw603.
Your 1 year guarantee your appliance carries a 1 year parts and labour warranty. To fulfil the conditions of your guarantee, the appliance must be correctly installed, operated in accordance with the instructions and only be used for normal domestic purposes. Please note that the guarantee and servi...
At time of delivery • check the packaging and dishwasher immediately for signs of transport damage. If the appliance is damaged, do not put it into use but contact your supplier or customer service department. • check you have received all the components required for the installation of this applian...
Safety information during installation site the dishwasher and connect it up in accordance with the installation instructions. The dishwasher must not be connected to the electricity supply whilst installation is being carried out. Ensure that the domestic wiring is properly earthed. The mains elect...
Consult the section entitled “troubleshooting” at the back of the manual. If you cannot solve the problem, contact a service centre. Only specialised engineers are authorised to make repairs. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali...
When disposing of old appliances.
Installation positioning the appliance position the appliance in the desired location. The rear of the appliance should rest against the wall behind it and the sides, along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can be positioned to the left...
Cold water connection if the water pipes are new or have not been used for some time, let the water run to make sure that the pipe is clear and free from impurities. Failing to do so may result in the water inlet becoming blocked and the appliance may be damaged as a result. Connect the water supply...
Attached to the water supply tap as shown in fig 2. No other type of connection is acceptable. The water supply hose must not, under any circumstances, be cut as it contains electrical parts which are live. If the hose length is not adequate to make a proper connection, the hose must be replaced wit...
Electrical connection (uk only) for your safety, please read the following information. Warning: this appliance must be earthed. This appliance must be connected to a 220-240 volts, 50hz cycle ac supply by means of a three pin socket, suitably earthed and should be protected by a 13 amp fuse. This a...
The maximum dimensions and weight for the décor door are as follows: height: 725mm width: 598mm thickness: 20mm weight: 7kg the following steps should be taken to fit the décor door: measure the width of the décor door align the top of the template (supplied) with the top of the rear side of the déc...
The dishwasher should be secured to the underside of the worktop via the two fixing holes in the top trim. For non-wooden worktops (e.G.; marble) two solid worktop fixing brackets are provided to allow the appliance to be secured to the sides of the adjacent cabinets. These should be secured to the ...
Installing the plinth position the dishwasher in the cut out in the kitchen cabinet. Install the continuous plinth according to the manufacturer’s instructions. Slowly open the dishwasher door to see if it interferes with the plinth. If so, rest the bottom edge of the décor door panel against the pl...
Getting to know your dishwasher a upper rack g washing filter b lower rack h detergent and rinse aid dispenser c top spray arm i water inlet hose with aquastop d silverware basket j drain hose e bottom spray arm k power supply cord f salt container cap d.
How to fill the salt container.
The default setting of the water softening system is “ - “. If using multi-functional tablets, fill the salt dispenser and set the adjuster to “ - “. If the hardness of the water is greater than 60° fh , set it to “ + “..
How to fill the rinse aid dispenser.
How to fill the detergent dispenser.
Not suitable for the dishwasher.
Dishwasher arrangement.
After pushing the racks back into position, always make sure the spray arms can rotate freely and are not obstructed by the dishes in the rack..
Washing dishes note : the use of 3 in 1 or similar tablets is not recommended when using the rapid wash and soak programmes..
End of programme • six beeps will indicate that the wash cycle has finished and all the programme indicators will illuminate. Switching the dishwasher off several minutes after the programme has ended: • open the door • press the on / off button to switch the appliance off • remove pots once they ha...
Half load function the half load button “c” makes it possible to wash dishes using only the upper rack if there are not enough dishes for a full load. This will allow you to save on water and energy consumption. To select ½ load: • select the required programme. • press the ½ load button “c” and the...
Programme overview.
Care and maintenance.
Troubleshooting.
Technical data.
Appliance365 end user warranty conditions the conditions below outline the prerequisites and scope of the warranty offered by appliance 365 limited (“we / us”) to consumer end users of appliances supplied by or through us. Please note that these conditions do not affect your statutory rights or the ...
Be complete. A purchase receipt with date of purchase or delivery must be presented prior to commencement of any repair or replacement. Replaced parts pass into our ownership. 7. Service may not be available in all of the islands around the uk and ireland. Please check with your retailer or contact ...
Note: consistent with our continuing product development policy, improvements may have been made which render the contents of this package slightly different to that shown. Model no. Udw603 november 2009 appliance 365 limited cranage house 730 mandarin court centre park warrington united kingdom wa1...