225rg kit-aa h i g h p e r f o r m a n c e f r o n t s p e a k e r a n d a m p l i f i e r k i t installation manual 225rg kit-aa h i g h p e r f o r m a n c e f r o n t s p e a k e r a n d a m p l i f i e r k i t for use on 1998-2013 “road glide” model bikes with factory radios installation manual ...
2 thank you for choosing the hogtunes 225 rg kit-aa for 1998-2013 road glides. Since positive word of mouth is the best way to grow our business, we want your new system to work as well as it was designed to. If you have any questions or concerns, we are here to help. To help protect your bike’s ele...
3 installation instructions step #1: remove the seat and both wires (+ and -) from the battery. Step #2: remove the outer fairing/headlamp assembly and set it aside. Refer to a service manual if you need help with this. Note: a towel on the front fender can help prevent scratches or “dings” from dro...
4 wiring the amplifier step #1: locate the main power connector and plug it in to the mating connector on the amp. Locate the audio input harness and plug its 8 pin harness into “audio input” on the side of the amp. Step #2: on the input harness, locate the yellow/black pair of wires with the male c...
5 step# 4: on the brake side of the bike, in front of the gas tank, on the side of the frame’s backbone, there is a rectangular opening where a large wire harness (and throttle/idle cables on ‘98-’07 bikes) pass through from the fairing side of the bike. The red and black wires for the amp will pass...
6 amplifier wiring diagram green/black from amp plugs into brake side factory speaker wires brown/black wires from amp plug into clutch side speaker blue/black wires from amp plug into brake side speaker yellow/black from amp plugs into clutch side factory speaker wires power and ground direct to ba...
7 system upgrade #1 this system is an easy way to add rear speakers to the bike if it has a king tour-pak®. Hogtunes rear speaker pods come with a wire harness set up for quick detach tour paks that will plug right into the expansion port on the amp. Important: since the radio power will be used to ...
8 system upgrade #2 this system has the incredible power of two (2) rev 225-aa amplifiers! The amp that came in this kit will power the 5”x7” fairing speakers while the second amp will bolt in and can be used to power hogtunes 6”x9” saddle bag speaker lids or fairing lower woofers. Note: to mount th...
9 system upgrade #3 this system uses an nca 450-aa (200 watt 4 channel amplifier) as well as hogtunes rev 225-aa (225 watt 2 channel amplifier) for the ultimate in real power! As shown below, a typical system would have the 4 channel amplifier power the fronts (and tweeter pod if present) and rears....
10 adjusting your system-please read! In order to make this new system perform as well as it was designed, please take a minute to understand and follow these tips: 1) set this “automatic volume control” (avc) to 3 bars. After extensive on-road testing, we found that this avc position works and soun...
11 harley-davidson, electra glide, road glide, street glide, ultra classic, tri glide, cvo, screamin eagle and tour-pak® are trademarks, and/or registered trademarks of harley-davidson, inc., milwaukee, wisconsin, usa, and if used or implied are for reference only. There is no affiliation between ha...
Hogtunes products will play much louder than the original equipment, which can be a distraction to the rider and/or passenger. Please use caution when adjusting or playing your stereo at high volume, especially in traffic. You are a valued customer so please: ride alert arrive alive! Www.Hogtunes.Co...
