Hogtunes Big RG Installation Manual

Summary of Big RG

  • Page 1

    D esigned and e ngineered in c anada f or t he g reat a merican c ruiser for use on road glide ultras or road glides with king tour paks and rear speaker boxes *do not install this kit if any external amplifier to the radios built in power is present. This includes “cvo” models with factory amplifier ...

  • Page 2

    Getting started step #1: remove the seat, and both wires (+ and -) from the battery. Step #2: remove the outer fairing/headlamp assembly. Refer to a service manual if you need help with this. Note: a towel on the front fender can help prevent scratches or “dings” from dropped tools or fasteners etc....

  • Page 3

    5 wiring the amplifier on all input/output and speaker connectors, it’s a good idea to take the female spade connector and gently squeeze the connector together. Doing so insures a solid connection when the male spade connector goes in. Do not have the male and female connectors together, and then s...

  • Page 4

    7 step #2: turn the stereo on, and at low volume, test to make sure all 4 speakers are working. Note: the system will sound radically different at speed than it does in your garage. We suggest leaving the system with the bass and treble in the center position (flat), and adjusting while at speed. Re-...