Holder 2750-AP Owner's Manual - Parts
Angle Plow
Owner’s Manual and Parts List
Page | 13 of 19
Holder Tractors Inc.
www.holdertractors.ca
PARTS
Illustration may not necessarily reproduce the full detail and exact shape of the parts or depict the actual
models and are intended for reference only.
Please include the model, make, serial number, and the part number to place an order.
Right hand and Left hand sides of the tractor are determined from the viewpoint of the operator when
seated in the tractor.
The dealer reserves the right to change or eliminate the product, specifications or product line without
notice or obligation.
• -- The last two numbers in the model number represents the width of the plow
Plow number 4160-AP has a blade width of 60”, where
Plow number 4172-AP has a blade width of 72”.
• -- O/L means that the part common hardware which can be “Obtained Locally”.
• -- N/S means that the part is Not Shown.
• -- Quantities indicated are for the 60” angle plow, and may vary for larger or other models.
• -- Top link and Block, Safety chain and Pin are not included with the Plow.
• -- Please note that “XX” denotes the width of the angle plow blade. Thus the part number for a 60”
angle plow’s blade and turntable assembly would be M-AP-60-001, but for a 72” angle plow it
would be M-AP-72-001. Quantities indicated are for 60” angle plow, and may vary for larger or
other models.