Holland FW3110 Operating Manual

Summary of FW3110

  • Page 1

    Xl-fw1114-01 1 fw3510 fw3510/fw3410 & fw3110 fifth wheel operating manual warning you must read and understand the instructions in this manual before operating your fifth wheel. Failure to follow all of the important operating procedures contained in these instructions may result in a hazardous cond...

  • Page 2

    2 xl-fw1114-01 rev. A 1. Component part identification and specifications 1.1 identification of component parts (standard greased fw3510 shown) 1.2 important specifications release handle spring yoke lock jaws lock pin grease fittings cam plate adjustment bolt and nut grease grooves lock pins lock j...

  • Page 3

    2. Operating instructions 2.1 pre-service inspection 2.2 trailer coupling procedure tilt down 1 2 4 3 1 1 3 4 5 6 2 xl-fw1114-01 rev. A 3 inspect the fifth wheel mounting. Make sure the coupling area is flat, level and clear of obstacles and persons lubricate the fifth wheel-to-trailer contact surfa...

  • Page 4

    4 xl-fw1114-01 rev. A 2. Operating instructions (continued) 2.2 trailer coupling procedures (continued) 7 8 9 1 10 fifth wheel must lift trailer ➠ ➠ 100 - 150 mm ➠ ➠ ➠ ➠ no gap! 1 2 3 4 release handle notch is locked in the casting pull handle without using “trigger”. Handle should stop against cast...

  • Page 5

    Xl-fw1114-01 rev. A 5 2. Operating instructions (continued) 2.2 trailer coupling procedures (continued) use low gear! Secure handle 1 1 1 use low gear! Secure handle 11 1 2 3 4 5 6 12 7 9 10 8 13 retract landing gear until pads come off the ground. Re-check brake lines and light cord. Remove chocks,...

  • Page 6

    6 xl-fw1114-01 rev. A 3. Maintenance procedures 3.1 as needed lubrication note: maintain adequate lubrication on the following surfaces by inspecting and re-lubricating at regular intervals. Grease the trailer contact surface area* *not required for the fw3310 & fw3110 models. Lock jaws and front lo...

  • Page 7

    Xl-fw1114-01 rev. A 7 3. Maintenance procedures (continued) 3.2 required inspections and adjustments (continued) note: perform the following every three (3) months or 50,000 km, whichever comes first. Thoroughly steam clean all components before inspecting or adjusting. 3.2.2 inspection of locking m...

  • Page 8

    8 xl-fw1114-01 rev. A copyright © september 2005 • the holland group, inc. Holland europe gmbh altenkamp 9 d-33758 schloss holte-stukenbrock germany phone: +49 (0) 5207-89560 fax: +49 (0) 5207-895656 the holland group, inc. Holland, mi 49423 united states phone: (616) 396-6501 fax: (616) 396-1511 ho...