Holland The Heritage BH-421-SG-5 Instruction Manual - page 6
H-4
Figure 4b
Figure 4a
Figure 4c
Figure 4d
Attach Electrode Wire
Ignition Electrode Wire
14
11
13
12
Select the following parts for assembly:
No.
Description
11
Grill bottom assembly
12
Ignition electrode
13
Bottom mount
14
Shelf brackets (4)
4a. Refer to Fig. 4a
Install the ignitor electrode into the grill bottom as
shown using a #8-32 screw to secure. Leave the elec-
trode wire loose for now.
4b. Refer to Fig. 4b
Locate the grill bottom mount bracket to the grill bot-
tom with the clearance holes in the bracket fitting over
the bolt heads for the flame deflector plate. Install the
1/4–20 bolts and lockwashers to secure.
Attach the (4) shelf brackets to the grill bottom while it
is still upside-down. Use the 1/4–20 bolts and lock-
washers to secure.
4c. Refer to Fig. 4c
Invert the stand tube and support assembly (previously
assembled) and position it over the grill bottom mount.
CAREFULLY feed the electrode wire up into the stand
tube and out through the hole in the front of the tube
as you lower the stand tube assembly in place. Slip the
open end of the tube OVER the projecting flanges of
the bottom mount.Align the three holes in each side
and install a bolt and lockwasher in each.When all are
started, tighten securely.
4d. Refer to Fig. 4d
Attach the loose end of the electrode wire to the termi-
nal on rear of ignitor body on back of control panel.
SPARK IGNITOR
At this point you should check to see that the Spark
Ignitor is working properly. Rotate the Ignitor knob
CLOCKWISE and observe the electrode tip inside the
grill body, next to the burner head.You should see a
small blue spark upon every actuation of the spark
mechanism.
After the stand tube assembly and shelf brackets are
installed and the ignitor is working correctly, turn the
grill over onto its wheels.