Holux M-1200A User Manual - Table of Contents

Manual is about: Bluetooth GPS Receiver

Summary of M-1200A

  • Page 1

    Holux m-1200a bluetooth gps receiver user’s manual m-1200a bluetooth gps receiver 07,2007 rev.A holux technology inc. 1f, no. 30, r&d rd. Ii, hsinchu city 300, science-based industrial park, taiwan tel: 886-3-6687000 fax: 886-3-6687111 website: www.Holux.Com all right reserved user’s guide.

  • Page 2: Table of Contents

    Holux m-1200a bluetooth gps receiver manual 2 table of contents table of contents ..................................................................................................2 1. Overview .............................................................................................................

  • Page 3: 1. Overview

    Holux m-1200a bluetooth gps receiver manual 3 1. Overview (fig.1) the holux m-1200a bluetooth gps receiver (fig. 1) is a total solution gps receiver with bluetooth, uart interface and built-in rechargeable battery for high sensitivity to tracking signal. M-1200a design is based on mediatek inc.(mtk)...

  • Page 4: 2. Packing List

    Holux m-1200a bluetooth gps receiver manual 4 2. Packing list thank you for purchasing the m-1200a bluetooth gps receiver. Before you start, make sure that the following items are included in your package. If any of these items are missing, please contact your original local holux dealer or distribu...

  • Page 5: 3. Main Features

    Holux m-1200a bluetooth gps receiver manual 5 3. Main features z built in mtk mt3318 low power consumption gps chipset. Z 32 parallel satellite-tracking channels for fast acquisition and reacquisition. Z superior sensitivity up to -159 dbm. Z built-in waas/egnos demodulator without any additional ha...

  • Page 6: 4.Technical Specification

    Holux m-1200a bluetooth gps receiver manual 6 4.Technical specification 4.1. Basic specification z chipset:mtk mt3318 chipset . Z channels: 32 parallel satellite-tracking channels. Z frequency: 1575.42 mhz z receiver: l1, c/a code. 4.2. Acquisition time (refer to mtk chip specification) z reacquisit...

  • Page 7

    Holux m-1200a bluetooth gps receiver manual 7 data bit: 8 parity: no stop bit: 1 ii. Format. Nmea0183 v3.01: gpgga (1time/1 sec), gpgsa (1 time/5 sec.), gpgsv (1time /5 sec.), gprmc (1time /1 sec.), gpvtg (1 time/1 sec), (gll, or mtk nmea command for optional). Iii. Datum: wgs84. Z input/ output int...

  • Page 8: 5. Getting Started

    Holux m-1200a bluetooth gps receiver manual 8 5. Getting started step 1. Charge battery please charge battery till led off for the first time. Power cable plug in power cable connect to power socket ↓ charge battery battery indicator light: power too low -------- red led charging -------------- gree...

  • Page 9

    Holux m-1200a bluetooth gps receiver manual 9 5.1. Hardware description 1). M-1200a body description see fig. 2: (fig.2) led of battery( red / green ) bluetooth led ( blue ) led of gps ( orange ) power switch.

  • Page 10

    Holux m-1200a bluetooth gps receiver manual 10 2). Led status : 3). Power switch : a. Power on, orange light is on. B. Power off, orange light is off. 4). Power jack & data port, see fig.3 jack type: mating face of 5 pin mini usb type b female. Pin definition see table 1. (fig.3) table 1 pin pin nam...

  • Page 11

    Holux m-1200a bluetooth gps receiver manual 11 5). Optional accessories, and connector description, see fig. 4 (fig.4) notics : this data cable is designed by holux specially for g-mouse function, can’t be replaced by common usb cable. The ordinary usb cable can only provide the charging function. U...

  • Page 12: →

    Holux m-1200a bluetooth gps receiver manual 12 5.2. Bluetooth device connection installation the following is the steps of software installation to setup on pda, dell axim x51v with bluetooth manager. For other pda or laptop device, the steps might vary. 1. In pocket pc settingÆsystem panel, enable ...

  • Page 13

    Holux m-1200a bluetooth gps receiver manual 13 6. Go to the “com ports” panel to tap “new outgoing port”, choose “holux_m-1200a” device and tap “next”. 7. Select the com port, then tap finish, it will show as right figure, and tap “ok” to finish the bluetooth setting. Recommand not to use “secure co...

  • Page 14

    Holux m-1200a bluetooth gps receiver manual 14 2) setup the baud rate : 38400, then tap “scan” button to scan your com port. Select your com port respectively, then tap “open gps” button. Check log screen below if the satellite data is receiving correctly. (fig. 6) 3) select “gps status” panel to ob...

  • Page 15: 7. Driver Installation

    Holux m-1200a bluetooth gps receiver manual 15 6. Optional cable accessory option cable accessory is provided to meet customers’ need, see table 1. With the data cable connected, it can transmit data with pda, notebook easily as the g-mouse role. Table 1 item description note gr230-a2 holux usb data...

  • Page 16: 8. Warranty

    Holux m-1200a bluetooth gps receiver manual 16 8. Warranty the m-1200a is warranted to be free from defects in material and functions for a period of one year from the date of purchase. Any failure of this product within this period under normal conditions will be replaced at no charge to the custom...

  • Page 17: 9. Troubleshooting

    Holux m-1200a bluetooth gps receiver manual 17 9. Troubleshooting problems possible reasons methods weak or no gps signal at the place of m-1200a test under open sky at a fix location and run mini gps viewer “cold start” function. No gps output but gps timer is counting the ephemeris and almanac dat...

  • Page 18

    Holux m-1200a bluetooth gps receiver manual 18 federal communications commission (fcc) statement this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against h...