1. DL manuals
  2. HomComfort
  3. Patio Heater
  4. HCPHMSQ
  5. User Manual

HomComfort HCPHMSQ User Manual

Manual is about: ANSI Z83.26-2007/CSA 2.37-2007 Gas-Fired Outdoor Infrared Patio Heaters ANS Z83.26a-2008/CSA 2.37a-2008 Gas-Fired Outdoor Infrared Patio Heaters

Summary of HCPHMSQ

  • Page 1

    Model # bfh-a bfc-a outdoor patio heater 1 ans z83.26-2007/csa 2.37-2007 gas-fired outdoor infrared patio heaters ans z83.26a-2008/csa 2.37a-2008 gas-fired outdoor infrared patio heaters us r c r r danger if you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. If odor co...

  • Page 2

    Package contents 2 n o i t p i r c s e d t r a p quantity 1 reflector flame screen flame screen glass tube protective guard 1 l m n gas hose & regulator control box assy lower support block belt 4 1 1 1 wheel assembly bottom plate n o i t p i r c s e d t r a p quantity a reflector 1 b 1 c glass tube...

  • Page 3

    Hardware contents (shown actual size) 3 safety information please read and understand this entire manual before attempting to assemble, operate or install the product. This manual contains important information about the assembly, operation and maintenance of this patio heater. General safety inform...

  • Page 4

    4 safety information danger • carbon monoxide hazard • this heater is a combustion appliance. All combustion appliances produce carbon monoxide (co) during the combustion process. This product is designed to produce extremely minute, non-hazardous amounts of co if used and maintained in accordance w...

  • Page 5

    5 preparation before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents above. If any part is missing or damaged, do not attempt to assemble the product. Contact our customer service for replacement parts. Estimated assembly...

  • Page 6

    6 assembly instructions hardware used ee ff jj hardware used 1 2 1. Assemble the wheel assembly to the bottom plate. Fix the wheel assembly to the bottom plate using 4pcs bolt m6x12 and 4pcs flange nut m6. 2. Insert the pins of the base to the holes of lower support, press to secure the pins. Using ...

  • Page 7

    7 assembly instructions hardware used kk hardware used 3 4 3.Assemble block belt. Fix the block belt to the 2pcs of lower support behind the front door,using 2pcs screw m5x12. 4. Assemble the middle support. Insert the 4pcs upper support to the lower support. Secure them with 8pcs screw 3/16”. X 1 p...

  • Page 8

    8 assembly instructions hardware used 5 6 5. Assebmle the flame screen to the upper support. Secure the flame screen to the upper support using 8pcs screw 3/16 ” . 6. Assemble the reflector onto the flame screen. Screw the 3pcs stud on the flame screen, put 3pcs washer ĭ6 onto the top of stud, then ...

  • Page 9

    9 assembly instructions 7 7. Carefully install the glass tube by lifting up and inserting through the center hole in the upper plate. Ensure the black silicone ring is attached to the lower edge of the glass tube as illustrated. Slide the glass tube through the hole of the lower plate cover and onto...

  • Page 10

    10 assembly instructions 9 10 9. Attach the three side panels to the heater using 18pcs screw 3/16”. Note : do not cover the front side where the control knob is. Ll mm h nn dd hardware used dd kk x 18 philips screwdriver 3/16” screw x 1 10. Install the knob to m4x10 screw. Hang the chain to the hol...

  • Page 11

    Assembly instructions 11 11. Screw gas hose and regulator to propane cylinder (not included). Do not cross-thread. Warning: use a standard 20 lb. Propane cylinder only. Use this heater only with a propane vapor withdrawal supply system. See chapter 5 of the standard for storage and handling of lique...

  • Page 12

    Assembly instructions do not store a spare lp-gas cylinder under or near this appliance; never fill the cylinder beyond 80 percent full; place the dust cap on the cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the cylinder valve that is provided with ...

  • Page 13

    13 operation instructions leak check 1. Make 2-3 oz. Of leak check solution (one part liquid dishwashing detergent and three parts water). 2. Apply several drops of solution where hose attaches to regulator. 3. Apply several drops of solution where regulator connects to cylinder. 4. Make sure all pa...

  • Page 14

    14 operation instructions danger • carbon monoxide hazard • for outdoor use only. Never use inside house, or other unventilated or enclosed areas. This heater consumes air (oxygen). Do not use in unventilated or enclosed areas to avoid endangering your life. Before turning gas supply on: 1. Your hea...

  • Page 15

    15 operation instructions 4. Push and release the igniter button until pilot flame is visible through the glass tube. 5. Once the pilot is lit, continue to depress the control knob for 30 seconds. 6. If the pilot does not stay lit, repeat steps 4 to 6. 7. If after repeating steps 4 to 6 unit does no...

  • Page 16

    Operation instructions shut down: 1. Turn control knob clockwise to pilot. (normally, burner will make a slight popping sound when extinguished.) burner will extinguish but pilot will remain on. 2. To extinguish pilot depress control knob and continue to turn it clockwise to off. 3. Turn cylinder va...

  • Page 17

    17 operation instructions care and maintenance 9. Heater is away from gasoline or other flammable liquids or vapors. 10. Heater is away from windows, air intake openings, sprinklers and other water sources. 11. Heater is at least 24 in. On top and at least 36 in. On sides from combustible materials....

  • Page 18

    18 care and maintenance gas odor with extreme yellow tipping of flame. Heater does not reach the desired temperature. Heater glow is excessively uneven. Heater makes popping noises. Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater and render it unsafe fo...

  • Page 19

    Troubleshooting problem possible cause corrective action pilot won’t light pilot won’t stay lit burner won’t light burner flame is low carbon build-up thick black smoke cylinder valve is closed open valve blockage in orifice or pilot tube air in gas line low gas pressure with cylinder valve fully op...

  • Page 20

    Distributed by: united states stove company 227 industrial park rd south pittsburg, tn 37380 www.Usstove.Com (800) 750-2723 1 year limited warranty - customers in the continental us all components are warranted for a period of 1 year after date of purchase by the original owner against defects in ma...

  • Page 21

    Replacement parts list n o i t p i r c s e d t r a p quantity 1 reflector flame screen flame screen glass tube protective guard 1 l m n gas hose & regulator control box assy lower support block belt 4 1 1 1 wheel assembly bottom plate n o i t p i r c s e d t r a p quantity a reflector 1 b 1 c glass ...