HomComfort HCPHSSWKR Owner's Manual And Operating Instructions

Manual is about: Outdoor Wicker Patio Heater - LPG (Liquid Propane)

Summary of HCPHSSWKR

  • Page 1

    Danger for your safety if you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. If odor continues, keep away from the appliance and immediately call you gas supplier or fire department. Danger warning do not store or use gasoline or other flammable vapors and liquids in t...

  • Page 2

    Package contents 2 reflector panel reflector plate a b c d e f g h n o i t p i r c s e d t r a p quantity a 3 b 1 c head assembly 1 d post h regulator 1 e tabletop 1 f main frame gas hose 1 g 1 1.

  • Page 3

    Hardware contents (shown actual size) aa ii dd ee hh cc kk ll ff bb gg reflector spacer qty. 3 washer ĭ8 qty. 9 washer ĭ6 qty. 9 screw m6 x 10 qty. 9 cap nut qty. 9 bolt m6 x 30 qty. 4 bolt m6 x 12 qty. 4 wrench qty. 1 jj wing nut qty. 3 stainless steel bolt m6 x 10 qty. 4 m6 flange nut qty. 4 safet...

  • Page 4

    4 safety information danger • carbon monoxide hazard • this heater is a combustion appliance. All combustion appliances produce carbon monoxide (co) during the combustion process. This product is designed to produce extremely minute, non-hazardous amounts of co if used and maintained in accordance w...

  • Page 5

    5 preparation before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents above. If any part is missing or damaged, do not attempt to assemble the product. Contact customer service for replacement parts. Estimated assembly tim...

  • Page 6

    6 assembly instructions 2 3 2. Put the tabletop (e) throught the support, secure the tabletop with 4pcs m6x12 bolts. 3. Put the deck ring (kk) through the post and above the tabletop. Hardware used ll bolt m6 x 12 x 4 hardware used kk deck ring x 1 e kk 1 1. Fix the support post (d) with 4pcs m6x30 ...

  • Page 7: 5-1

    7 assembly instructions 4 4. Attach reflector spacers (cc) and three washers Ø8 (dd) to screen cover. Tighten the reflector spacers. Cc dd x 3 reflector spacer x 3 washer ĭ8 hardware used hardware used ii 5-1 x 4 stainless steel bolt m6 x 10 5. Attach head assembly to post. 5-1. Unscrew four stainle...

  • Page 8

    8 assembly instructions hardware used ee ff gg 6 7-1 tt 6. Warning:remove protective cover before assembling. Note: if necessary for proper alignment of reflector sections, loosen each bolt prior to further assembly and retighten after sections are aligned. 7. 7-1.Slide two reflector panels together...

  • Page 9

    9 assembly instructions hardware used dd hh 8 9 8 . Support heater. Slide three washers washer ĭ8 (dd ) over threaded end of spacer. Locate reflector assembly on 3 spacers. Install three washers ĭ8 on spacers and securely tighten wing nuts (hh) but do not overtighten. 9. Connect hose and regulator t...

  • Page 10

    10 assembly instructions a dented, rusted or damaged propane cylinder may be hazardous and should be checked by your cylinder supplier. Never use a propane cylinder with a damaged valve connection. The propane cylinder must be constructed and marked in accordance with the specifications for lp gas c...

  • Page 11

    11 operation instructions leak check 1. Make 2-3 oz. Of leak check solution (one part liquid dishwashing detergent and three parts water). 2. Apply several drops of solution where hose attaches to regulator. 3. Apply several drops of solution where regulator connects to cylinder. 4. Make sure all pa...

  • Page 12

    12 operation instructions danger ‡&$5%210212;,'(+$=$5' ‡)rurxwgrruxvhrqo\1hyhuxvhlqvlghkrxvhrurwkhu xqyhqwlodwhgruhqforvhgduhdv7klvkhdwhufrqvxphvdlu r[\jhq'rqrwxvhlqxqyhqwlodwhgruhqforvhgduhdvwr dyrlghqgdqjhulqj\rxuolih %hiruh7xuqlqj*dv6xsso\21 khdwhuzdvghvljqhgdqgdssuryhgirurxwgrruxvhrqo\'r127xvhlw...

  • Page 13

    13 operation instructions 5. Push and release the igniter button until pilot flame is visible through viewing hole. 6. Once the pilot is lit, continue to depress the control knob for 30 seconds. 7. If the pilot does not stay lit, repeat steps 4 to 6. 8. If after repeating steps 4 to 6 unit does not ...

  • Page 14

    14 operation instructions shut down: 1. Turn control knob clockwise to pilot. (normally, burner will make a slight popping sound when extinguished.) burner will extinguish but pilot will remain on. 2. To extinguish pilot depress control knob and continue to turn it clockwise to off. 3. Turn cylinder...

  • Page 15

    15 operation instructions care and maintenance 9. Heater is away from gasoline or other flammable liquids or vapors. 10. Heater is away from windows, air intake openings, sprinklers and other water sources. 11. Heater is at least 24 in. On top and at least 36 in. On sides from combustible materials....

  • Page 16

    16 care and maintenance gas odor with extreme yellow tipping of flame. Heater does not reach the desired temperature. Heater glow is excessively uneven. Heater makes popping noises. Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater and render it unsafe fo...

  • Page 17

    17 troubleshooting n o i t c a e v i t c e r r o c e s u a c e l b i s s o p m e l b o r p pilot won’t light pilot won’t stay lit burner won’t light burner flame is low carbon build-up thick black smoke e v l a v n e p o d e s o l c s i e v l a v r e d n il y c blockage in orifice or pilot tube air ...

  • Page 18

    Distributed by: united states stove company 227 industrial park rd south pittsburg, tn 37380 www.Usstove.Com (800) 750-2723 1 year limited warranty - customers in the continental us all components are warranted for a period of 1 year after date of purchase by the original owner against defects in ma...

  • Page 19

    Replacement parts list reflector panel reflector plate a b c d e f g h n o i t p i r c s e d t r a p quantity a 3 b 1 c head assembly 1 d post h regulator 1 e tabletop 1 f main frame gas hose 1 g 1 1.