Home automation, inc. Model 32a30 touchscreen hub installation manual document number 32i30-1 rev b march, 2008.
Copyright © 2005-2008 home automation, inc. All rights reserved.
Introduction the hai touchscreen hub is used to provide power, communications, and a video signal to hai omnitouch touchscreens. Up to eight (8) omnitouch touchscreens, with or without video, can be connected; however, you may connect an additional touchscreen hub for a total of up to 16 omnitouch t...
Installation note: this unit has protection against static discharge in normal operation. However, use static discharge precautions during installation. Always touch the enclosure to discharge static before touching the connections. Note: do not make changes to terminal lock connections (tb1 – tb6) ...
Ca m e ra inp ut ter m in ati n g resisto r ju m per ca m e ra o ut p u t ca m e ra p o w e r 1. 5a ma x imu m zo n e (+ ) zo n e (- ) ha i c o nt rol ler gnd (gr ound) b / g r een a / y e llow g n d mus t be c o nnecte d t o g n d o n h a i cont roller ca t 5 c o nn e c t o r s o m ni t o u c h 5.7...
3. Low battery indicator (optional connection) when the backup batteries connected to the touchscreen hub become depleted, there are terminals on the touchscreen hub that are used to send a signal to the hai controller to alert you of the low battery condition. To take advantage of this feature, you...
Connecting to omnitouch (32a00-1) when connecting a standard omnitouch to the touchscreen hub, it is very important to plan where the omnitouch touchscreen will be installed and the gauge/type of wire you will use for the installation. The touchscreen requires a minimum of 4 wires for operation (2 f...
5. Camera connections the touchscreen hub takes the composite signal from any ntsc camera, digitizes it through the encoder, and then broadcasts it to the connected omnitouch with video or omnitouch 5.7 touchscreens. The touchscreen hub supports 6 individual cameras. In the areas marked camera 1 – c...
6. Connecting a second hai touchscreen hub when connecting more than 8 omnitouch with video touchscreens to an hai omnipro ii or hai lumina pro controller, a second touchscreen hub is required. To view video on the additional omnitouch with video touchscreens (the ones connected to the second touchs...
32 a3 2-2 v id e o en code r n yl o n s pacer 32a30-1, -2, -3 , - 4 tou chs cre e n hu b.
8. Power connections the supplied power pack provides both touchscreen (24vdc) and camera (12vdc) power. An ac power outlet should be located within 5 feet. One or two sealed, rechargeable batteries (not included) can be used to backup the touchscreen and camera (optional) power. The two battery cab...
Specifications operating 32 - 120 degrees f (0 - 49 degrees c) ranges: 10 - 85 % relative humidity, non-condensing power pack: output 19vdc, 3.79 amps, max 72w input 120vac, 1.8a amps, 60hz maximum power: 72 watts batteries: sealed, rechargeable, 12 volts, 4 - 8 amp-hours each low voltage cut out: 1...
