Home Hero VC9387 Manual - Using The Appliance
06 HOME HERO CARPET SHAMPOOER
USING THE APPLIANCE
Plug the cord into an electrical socket. Turn on the appliance by using the
on/off switch located on the side of the appliance.
IMPORTANT: Never leave the appliance unattended with the power on.
Turn off when emptying and filling tanks. Do not oversaturate the carpet.
1. Determine where you want to start and stop cleaning. We recommend
that right-handed persons start on the right carpet border and left handed
persons start on the left carpet border. Cleaning solution may leak out of the
shampooer once it is deactivated. For this reason, have a cloth laid out that you
can place the shampooer on after use.
2. Completely unwind the power cord from the hook, insert it in the cord
bracket and connect it with an easily accessible socket whose power voltage
corresponds to the shampooer’s technical data.
3. Press down the shampooer unlocking pedal and set the handle to a
comfortable position.
4. Using your foot, press the on/off switch to turn on the appliance.
5. Run the shampooer to a corner of the carpet.
6. Push the shampooer forward along the carpet border and depress the button for
emitting the cleaning solution. This will apply and brush the cleaning solution
into the carpet. In the process, walk next to the shampooer. Do not step on the
wet carpet! Once you have arrived at the other end of the carpet, release the
button.
7. Now go over the same strip in reverse. The dirty water will be vacuumed up.
8. Start the next strip slightly overlapping the cleaned carpet strip. Work with even
forward and backward movements up to the other edge of the carpet. In the
event of stubborn dirt, go over a strip of the carpet several times if necessary.
9. When the dirty water tank is filled to the max marking, it must be emptied
(see the “Cleaning the shampooer” section). If you would like to empty the
dirty water tank, fill up the fresh water tank or finish cleaning, switch off the
appliance by pressing the on/off switch, lay it on the prepared cloth, and bring
the handle to the upright position.
10. Remove the power plug from the power socket.