Home Improvement Products ECO CRUSH 400 Operation And Instruction Manual

Summary of ECO CRUSH 400

  • Page 1

    Eco crush 400 food waste disposer operation and instructions manual note:this food waste disposer has been designed to operate with your appropriate household current exclusively. Using any other voltage or hz adversely affects performance. Important:read all instructions thoroughly. Keep this guide...

  • Page 2

    1. Removal of old unit typical instructions, your model may vary. Note: if you have no existing unit to remove, simply take out you waste (plug) and proceed to section 2 before starting this step, turn off electrical power at the circuit breaker or fuse box. Unplug disposer. If your old mount is the...

  • Page 3

    2. Installation of mounting assembly please read completely before starting note: pay close attention to the order of mount assembly parts, as they have been correctly assembled by the factory (see 3a). Also, reference the cushion mount detail in illustration 3g for the proper position of the cushio...

  • Page 4

    Support ring (arrows pointing up) important notice: cushion mount detail when the cushion mount is installed correctly, the lip of the sink flange fits into the groove on the inside of the cushion mount and mount ring can be pulled downward over cushion mount and will be free to rotate. The bottom b...

  • Page 5

    3. Attaching discharge elbow a. Connect waste disposal elbow to the disposer (see 5a), - please note the direction of the gasket before removal. - remove the rubber gasket - fit the mounting over the elbow - replace the gasket the correct way as removed - secure the elbow to the disposer and secure ...

  • Page 6

    5. Dishwasher connection if you are utilizing a dishwasher, complete the following procedure a. Using a blunt instrument (steel punch or wooden dowel), knock out entire plug (see 2a). Do not use a screwdriver or sharp instrument. (when knockout plug falls into disposer, you may remove it or grind it...

  • Page 7

    7. Operating instructions the anti-jam swivel impellers make a clicking sound as they initially swing into place. This indicates normal operation. A. Remove sink stopper. Turn on a medium flow of cold water. B. Turn switch to on position;, or push your air switch button. Your motor is turning at ful...

  • Page 8

    10. Typical installations 11. Troubleshooting before seeking repair, we recommend that you review the following: loud noises: (other than those during grinding of small bones and fruit pits): these are usually caused by accidental entry of a spoon, bottle cap or other foreign object. To correct this...

  • Page 9

    11. Air switch instructions the disposer air switch assembly is supplied in three basic parts: the actuator which consists of: 1. Actuator button 2. Actuator nut 3. Actuator outlet(black threaded portion) the air switch sensor is installed into disposer. Only the air tube nozzle is visible from the ...